Your cart is empty.
Your cart is empty.Mark
Reviewed in the United States on January 30, 2024
Don’t waste your money if you think you’re buying a quality product. I’ve purchased a bunch of these different pigtails trying to find a quality one. The wires are really tiny, 1/4 of the oem size. The connector is cheap china plastic. The picture is the right part it will physically work but it’s not the same product as pictured, and the wires in the picture are way thicker and (green) these are black wires and super tiny. I’m sure Amazon loves returns
Christian
Reviewed in the United States on January 10, 2022
Harness fits perfectly where the old one was and was surprised to see that it came with butt connectors.
john smallwood
Reviewed in the United States on March 27, 2021
Could be better. Only a few dollars less then the Oe
Chuck L
Reviewed in the United States on October 28, 2020
Needed a new pigtail for an AEM 3.5 Bar Map sensor and found this one it worked perfectly if you need a new pigtail for AEM pressure sensor this is the one to get works perfectly. All three wire is weather-sealed and crimped pins are 100% intact just remember which is ground, signal, and .5volt power.
Josh
Reviewed in the United States on August 12, 2019
Worked great on my 2003 Excursion!
Ricky pennington
Reviewed in the United States on June 6, 2019
Exact replacement but wiring is skimpy not like oem. Get what you pay for but wouldn’t use on my personal truck for fear of melting wires down.
Tonya
Reviewed in the United States on June 26, 2019
Used on my truck
Rick M
Reviewed in the United States on December 3, 2018
The gauge in the wires is a bit thinner than OEM. I soldered the connections and used high heat insulating electrical tape. Then I used shrink wrap over all the connections and put the connector back in its heat protection. Truck fired right up after replacing the connector with this one.
Recommended Products
$13.00
$ 6 .99 $6.99