Your cart is empty.
Your cart is empty.Charged Air Manifold Dodge Ram 3500 All 2004-2007 Stock intake manifolds have sharp bends and corners. As air flows around these corners, dead air zones are created. These dead air zones choke down the air and restrict airflow to your engine.aFe's MDV technology uses smooth bends and directional vanes to form multiple air paths through the manifold. These new paths are smoother and shorter, producing much smaller dead air zones for increased overall airflow to the engine. Unique airflow path with MDV Technology Proprietary internal bolt design guaranteed to not deform and leak Cast A356-T6 aluminum construction Up to five port pads Custom black-zinc finished steel bracket of OE wire harness Faster turbo spool-up More horsepower Increased low-end torque for more towing power Improved boost pressure Stainless steel hardware Charged Air Manifold
Customer
Reviewed in the United States on July 8, 2017
I installed it in about 45 minutes.It came with all required hardware and intake gaskets.It improved throttle response and put a smile on my face; so I would say it's a great buy and I would recommend it.My cold air intake and turbo back exhaust will be delivered next week, so I am sure it will flow even better when those are installed.
Dakota Nelson
Reviewed in the United States on November 30, 2016
Easy install as described
Robert McGinness
Reviewed in the United States on March 26, 2015
Great product
Thomas Anderson
Reviewed in the United States on March 2, 2015
So far so good, can't say much because I haven't installed it but I got it today and man it looks great. Packaging was very protective, all hardware included as advertised. You really won't see a difference in performance with this piece unless you have some decent mods already on your truck i.e. Performance tune, intake, full exhaust, injectors, etc. This piece alone will not do a whole lot until your truck is pushing more HP than stock. I will update after install.----UPDATE---- mind you, my truck is stock except for an AFE stage 2 intake. After installing the intake, mileage went from 16.5 highway to 18 highway. After a 20 minute install of the bladerunner elbow here's the results: 22.2 mpg @ 75mph -increase of 4.2 mpg-24 mpg @ 55mph -increase of 6mpg-
Matt
Reviewed in the United States on March 6, 2014
Looks great, works great, easy to install! Make sure you run some sandpaper on the inside to get burrs off from casting and drilling. Convenient ports for boost gauges, water meth or nitrous injection. I have cooler egt's spool comes a bit earlier but I'm modded so can't say results for a stock truck! I would buy again!
Michael Vicoy
Reviewed in the United States on February 12, 2014
Good product to have on your truck. It will improve the trucks performance by having it breathe more efficient. Installation was quick and easy, you just have to take your time.
Warren
Reviewed in the United States on December 29, 2014
If I would have known then what I know now I would have not got it. do not notice any diff over stock
Customer
Reviewed in the United States on August 20, 2012
I had the plastic, CFM+ manifold but it melted. the AFE manifold is definately built better and seems to add a little power. Easy install, however the oil dipstick was hard to relocate. I recommend this product.
Recommended Products
$334.99
$ 99 .00 $99.00