Shopping Cart

Your cart is empty.

Your cart is empty.

Akron Mold Rubber Low Shrink Gray Label Pre-Cut Jewelry Wax Injection Mold for Jewelry Making, Mold Making and Vulcanizing, 25 Pieces Pre-Cut Size 1-7/8' x 2-7/8' x 1/8' Thick Made in USA

4.7 (1) Write Review
Free shipping on orders over $29.99

$21.98

$ 9 .99 $9.99

In Stock
  • 🟢 Pre Cut SIZE 1-7/8" x 2-7/8" x 1/8" Thick
  • 🟢 The Akron mold rubbers deliver controlled shrinkage, excellent cutting qualities, high tear resistance and elongation, and excellent fill and detail reproduction.
  • 🟢 It is especially suited for fine and detailed models.
  • 🟢 The mold material will never encounter variations in hardness or shrinkage.
  • 🟢 Gray rubber has a Dark Blue polyethylene cover
  • 🟢 Made In USA
  • 🔻 For more information check detail page 🔻


🟢 LOW SHRINK GRAY RUBBER LABEL AKRON PRE-CUT
🟢 Pre-Cut SIZE 1-7/8" x 2-7/8" x 1/8" THICK
🟢 PACK OF 25 READY CUT - JEWELRY MOLD MAKING
🟢 Akron Rubber is made by Zero-D Products in Akron Ohio, the polymer capital of the world.
🟢 The Akron mold rubbers deliver controlled shrinkage, excellent cutting qualities, high tear resistance and elongation, and excellent fill and detail reproduction.
🟢 The production formulations of the mold material contain certain waxes, oils and antioxidants, thus the molds made with the Akron will provide many years of production life.
🟢 Modern chemistry permits an uncured shelf life of 7 years or more, finished life of over 20 years.
🟢 The Low Shrink Gray is a Premium rubber that has a 40 Durometer, is perfect for molds where Extra Firmness and Minimal Shrink is required.
🟢 It is especially suited for fine and detailed models.
🟢 The mold material will never encounter variations in hardness or shrinkage.
🟢 Low Shrink Gray rubber vulcanizing Temperature of 310oF – Vulcanizer must be Calibrated Correctly and Pre-heated prior to making the mold.
🟢 NOTE: Pre-heat Vulcanizer to 310oF once it is ready vulcanizing time is 7 ½ minutes per 1/8"
🟢 The vulcanzing recommended temperature is 310oF, the temperature and time may be varied to suit your needs and experience...however do not exceed 325oF / 163oC
🟢 ***To produce good quality Molds... Always pack an extra layer of Mold Material (Example 1/2" thick Mold Frame will take 4 slices of 1/8" + 1 Extra layer = total 5)
🟢 The 5 pound package is enough to make 20-25 standard sized molds, depending on the thickness of the mold.
🔻 SPECIFICATIONS: JETS Product # 1309-9710 x25🔻
🔸 Each Ready Cut Piece Measures: 1-7/8" x 2-7/8" x 1/8" thick
🔸 310°F (154°C) - 7 ½ minutes per 1/8 inch – (Vulcanizer must be Calibrated Correctly).
🔸 Gray rubber has a Dark Blue polyethylene cover
🔸 SALE is for Ready-Cut 25 Pieces


Yasmani
Reviewed in the United States on April 22, 2024
The media could not be loaded.