Your cart is empty.
Your cart is empty.Product Description
Special suggestion:As long as it is the joint between metal and metal, screw glue is applied to any part to make the product more stable.
Great Guy
Reviewed in the United States on January 15, 2024
This shock tower kit is quite good. The aluminum is very light and bright red, and on my Stampede 4x4 I can see a little bit of both towers since I have the body somewhat high. And it looks beautiful.The front tower fit perfectly. The rear tower had an issue where the holes weren't quite lining up to the body's holes. So, I had to angle the bottom screws slightly, but enough to be awkward, and lightly force the screws in while I turned the allen wrench tool. At a certain point, the rear tower slowly got into place and the screws went it straight. I had to take off the tower for some reason, and then put it back on. That second time it aligned with the holes much more closely. The screws were still only a little angled, but not much, and then straightened out. It was as if the plastic body had to conform to the shock tower. Now, I'm confident that if I had to remove the tower again, the screws would line up just fine.That's really the only issue. Other than that, all screws for all other parts fit perfectly. The holes are threaded for stock screws. Everything is perfect! I haven't had a chance to run the car yet, but I'm keeping the body mounts to be plastic stock so that most of the shock will be absorbed by the mounts.
Recommended Products
$43.42
$ 22 .99 $22.99