Your cart is empty.
Your cart is empty. Reflective temperature of 300F, withstands radiant heat up to 2000F.
Capable of reducing up to 90% of radiant heat.
Adhesive backing sticks to almost any clean surface.
Helps shield fuel lines, brake lines, wire looms, and more from radiant heat.
Thickness: 0.032''(0.8MM).
Warning: Clean surface before applying, don't apply to any parts of exhaust system. Adhesive is rated up to 300℉ which is designed to block radiant heat only!
Poncho
Reviewed in the United States on February 13, 2024
This is thick and high quality! The first sheet I purchased was thin. This material is stiff.
William H. Moran
Reviewed in the United States on November 19, 2024
I used it on a plastic motorcycle panel covering the muffler instead of the $85 OEM pre-cut heatshield. It works well as a heat barrier but didn't stick. I ended up using 3M spray adhesive to keep it attached to the plastic panel which worked fine.
Susan
Reviewed in the United States on August 5, 2023
Looks good, can't wait to use it.
Luis Difo
Reviewed in the United States on August 1, 2022
Motorcycle muffler side panel.
robert dubreuil
Reviewed in the United States on November 18, 2022
i used the heat shield on under side of kitchen cabinet over air frier/oven which emits a lot of heat shield seems to do the job so far.
COMP1000
Reviewed in the United States on July 22, 2021
It doesn't stick well. Even after cleaning area with alcohol it didn't stick for long
Jeff walker
Reviewed in the United States on October 17, 2020
Easy to use
Jan
Reviewed in the United States on January 25, 2020
I have had to use staples to hold it in place
Recommended Products
$99.85
$ 39 .99 $39.99