Your cart is empty.
Your cart is empty.This bit is designed specifically for use for the karran stainless steel edgesinks for laminate and 1/2" Solid surface materials. They trim The counter-top edge after the bowl is mounted.Trim a sink cutout flush with the bowl in stages using these "over-hang" and flush trim bits in tandem. The overhang bits are equipped with non-marring ultra-glide bearings that are tapered to match the slope of the bowl's side. A first pass with the appropriate overhang bit cleans the cutout edge, leaving a very slight overhang at the underside of the counter. A pass with the flush-trim bit completes the operation, #57155, diameter (D): 49/64, angle (a°): 5°, cutting height (B): 1-1/2, Shank (D): 1/2, overall length (L): 3-D/2, type: 1/8 over hang, replacement bearing: 47733, flutes: 2, a: 1/2 or 3/4, 57155 carbide Tipped sink and trim with ultra-glide ball bearing guide solid surface 49/64 dia x 1-1/2 x 12 Deg x 1/2 inch shank
Michael McCadden
Reviewed in the United States on July 2, 2024
I have owned and operated a Corian®/solid surface fabrication business for 35 years and have used the Amana Tool - 57155 Carbide Tipped Sink & Trim with Ultra-Glide Ball Bearing Guide for 30 of those years, five days a week.
O.H. Custom Calls
Reviewed in the United States on September 30, 2020
The bearing failed halfway through the routing pass of a sink. This resulted in me gauging the sink.
Rob Gould
Reviewed in the United States on June 15, 2019
This works as it should for karran undermount sinks in laminate. It is the ONLY one that will work without damage to the sink. Between the cost of the epoxy gun that you HAVE to HAVE, and this router bit, I'm gonna put a sink in every room and 3 in the kitchen. I'll get my money out of it somehow! But....it worked great, and the sink looks amazing.
Kiowana Bob
Reviewed in the United States on March 24, 2019
I used ot for my sink cutouts. It worked perfect and is still sharp.
Customer
Reviewed in the United States on April 30, 2015
Worked out really well . Used it for coriander..
Rusty Chisel
Reviewed in the United States on October 16, 2009
This is a must for under laminate stainless steel sinks. The nylon bearing leaves no mark on the sink. I tried a standard bearing and it instantly leaves a mark. Costly price, but there are no other options that I am aware of. I finished off with a matching 10 degree bevel bit.
Recommended Products
