Your cart is empty.
Your cart is empty.Lenny H
Reviewed in the United States on January 13, 2025
This is well made and allowed for a nice secure temporary mount for the cell signal booster I required at my daughter's wedding. The wedding was at her house which has very poor reception, but the addition of a booster gave everyone a much more stable connection.
JB
Reviewed in the United States on September 9, 2024
Ordered this ANTOP AT-723 J Pole - Outdoor TV Antenna Mount with Adjustable Angle to mount a weather station at the lake property my family owns. Very straightforward and like any other pole mount I have installed in the past. Single mounting holes on the top and bottom of the mount. Easily adjustable with regard to vertical angle. The included lag screws are pretty hefty and I used a smaller gauge. Heavy well made pole with no issues.
RF
Reviewed in the United States on August 17, 2024
Got this to mount on my gable end eaves. It only has two bolts down the center axis so doesn't have quite the strength of a 4 corner bolt system. But it works and is likely adequate for smaller antennas in low wind load areas.
HalfTechnical
Reviewed in the United States on August 15, 2024
For some reason I was expecting this mount to be a bit more beefy. Maybe an unrealistic expectation I guess. No matter, I mounted my 5G cellular antenna in my attic to this mount and it worked well. It is attached to a 2x4 and is pretty solid. It is a rather large and somewhat heavy antenna, but in the attic I don't have to worry about the wind getting to it. The outer finish looks to be powder coat and should hold up well in outdoor use over time. It comes with the generic wall anchors that I have always replaced with heavier duty stuff from the HW store. The other hardware looks decent though. All in all, a decent mount.
Ty
Reviewed in the United States on August 10, 2024
Got this to J Pole mount to put up my dual band ham antenna which I'm using as a base station.The kit comes with everything you need to mount this to either a stucco or wood wall.Assembly is super easy and I got my UHF radials mount within an hour. Mounted the antenna and everything works. The kit is painted black and is made from steel.Any issues? Nope, like I had mentioned. I'm using this J Pole kit to mount a ham radio antenna and it works great. This can be used to mount other antennas like Starlink, Dish, or a Yagi broadcast type antenna.
Charlie
Reviewed in the United States on November 21, 2024
This mast is for very lightweight use only. It only has two mounting holes rather than the more typical four, so it's very prone to side to side sway. I didn't even trust it enough to use on its own, so it got relegated to use as a reinforcing support on a larger antenna mast.
Josh in Seattle, WA
Reviewed in the United States on October 18, 2024
I actually wanted to use this to mount a weather station I got for Christmas last year. The station consist of a part that has a pole mount directly molded into it. That is there's a relief in the main body that you slide on the end of a pole. I purchased this with the assumption that a TV mount would be approximately the same standard as most residential mounting solutions in the USA. However this one is literally about an eighth of an inch two wide in diameter for the station to fit on the end of it. Which is really disappointing. You could obviously use some sort of U-bolt scenario to mount antennas at a 90° angle for Yagi and other directional designs. For me I actually wanted it to point upwards to the sky and be parallel to the wall it's mounted to and slip something on the pole's end.While not the manufacturer's fault I feel like potentially you're going to run into a problem where you have different diameter requirements and so they should've been thought up when they were making the pole so that potentially the end or various spots in the middle would use different diameters that you could cut the pole (if need be) to access them to or get a smaller U-bolt around from a antenna kit.I'd only recommend this to someone who's going to use a U-bolt style solution. I do not recommend this for something that uses a "topper" solution that sits on the pole directly.
Jorgey
Reviewed in the United States on October 1, 2024
The "ANTOP AT-723 J Pole - Outdoor TV Antenna Mount with Adjustable Angle" is actually sturdier than I expected it would be.For the size and price, I did not think that this would be all that sturdy. I knew it would work for my needs so I was not worried about it and was pleased when I got it that it really was pretty sturdy. If you live in an area with high winds or you are trying to mount a large antenna, you need a larger mount that has more a anchor points on it, just not the two.Due to some restrictions I have, I needed something to mount a small Yagi antenna in my attic. This mount worked out great for the job. it worked perfectly and no issues at all.
Recommended Products