Your cart is empty.
Your cart is empty.Anyray A1704Y (5)-Pack 35 Watt T4 G8 35W Light Bulb JCD Type GY8.6 35Watt bi pin 110v 120v 130volt lamps. All of our lamps are Dimmable and can be used in conventional dimmers. Your Local stores sell similar lamps for $9.99 each bulb.
Customer
Reviewed in Canada on January 17, 2025
Used for replacing outdoor light bulbs, working well so far, fraction of cost from retail store.
Customer
Reviewed in Canada on February 21, 2024
Used these for microwave hood fan replacement. They don’t turn off
Maria Collier
Reviewed in the United States on December 1, 2023
Great for my outside lights. Less expensive than the big box stores also.
BakerDZ
Reviewed in the United States on October 15, 2023
does the job. hasnt blown out yet after 3 weeks
J. Chapman
Reviewed in Canada on June 17, 2020
Bright lights, worked well, came in a box of 5, packed nicely, will order again when needed.
Customer
Reviewed in Canada on March 5, 2020
These are outlasting the store bought major brand. Just remember to use gloves or towel when installing to avoid oils on bulb.
SLH
Reviewed in the United States on December 24, 2019
Works great for my microwave and a fraction of the cost versus name-brand appliance parts prices. I don’t know about the longevity yet, but assume it’s about as good as the original.
Nester626
Reviewed in Canada on August 25, 2018
Fit perfect. Couldn't get a higher wattage tho
Quotes&More
Reviewed in the United States on March 24, 2018
Great quality, long-lasting. Working a long time and well in my microwave and in a desk lamp. I am very pleased with the quality of these bulbs. Further, they come individually wrapped and if you snip off the end of the wrapping on each one, you have a way to hold them not to get finger oil on them (which makes halogen bulbs fail sooner). It's nifty.
E in SF
Reviewed in the United States on March 28, 2016
You can bend the prongs to fit if they don't fit perfectly. I ordered the size stated on the lamp, but the prongs were differently spaced from those of the original bulb. I bent them and they worked in the lamp. Remember not to touch the bulb with your bare fingers (I used a kleenex to insert it into the lamp) or, if you do touch it, clean it carefully with rubbing alcohol and dry it before inserting it into the lamp. Otherwise, you create a "hot-spot" due to the oil on your fingers and the bulb will overheat in the area that you touched and will burn out quickly. These bulbs get VERY hot!
Charles Swiger
Reviewed in the United States on April 23, 2016
Yay, these bulbs fit my lamp. (Even with a ruler, G8 vs G8.6 size is tough to be sure about.)The brightness is pretty good-- fine for a reading light, anyway. The two bulbs I'm using have lasted a couple of weeks of being on for ~6 hours a day, so they seem to be lasting fine so far.
Michael Beeson
Reviewed in the United States on October 19, 2015
It's probably just fine. It's just that I found out that the lamp I intended it for has a built-in transformer so although it plugs into wall current, I actually needed a 12 volt bulb. I didn't return these because it was my mistake, no fault of Amazon's or the seller. But as a result, I don't know how well the bulbs actually work.
Mark in Colorado
Reviewed in the United States on September 18, 2013
My desk lamps are halogen and use this 35 watt bulb. I found that a 35 watt bulb like this is very hard to find locally and when I did find them, they were more than $6.00 each! Here is a hint when installing halogen bulbs: Do not touch the bulb with your bare fingers. The residual oil on your fingers will cause a "hotspot" on the bulb and cause premature failure. Take the bulb out of the package, wipe it thoroughly with an alcohol swab and use a gloved hand to install in the lamp in the socket. Wipe it again with the alcohol swap once it is installed and be certain that it is dry before you turn on the lamp. Great buy and highly recommended.
Recommended Products
