Your cart is empty.
Your cart is empty. Brand New Universal Heavy Duty Weld On Steering Shaft U-Joint
7/8" Round Bore On Both Sides For Weld-On Installation
Greased Needle Bearings With Teflon Seal
High Quality Heat Treated Forged Steel Design
Specifically Designed For Racing Applications
⚠ California Proposition 65 WARNING: This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.
Matthew Buckley
Reviewed in the United States on September 18, 2023
Good product for the money
red neck
Reviewed in the United States on June 17, 2023
This is a very well made U-Joint. I used it for a steering shaft on an old Willys jeep that I made into a hunting buggy. I needed to tilt the steering column off my lap. The old Willys were tight on driver space and I am tall, so I spliced this into the column and it works great. It was a little tight for the 7/8" shaft, but I ground it down slightly and then welded it on no problem. I would highly recommend it if you need a steering U-Joint.
Customer
Reviewed in the United States on December 25, 2019
Fine product
Recommended Products
