Shopping Cart

Your cart is empty.

Your cart is empty.

ASTARPRO - Steering Rack and Pinion Tie Rod Boots Replacement for Audi Cabriolet Ford Escape Mazda Tribute Mercury Mariner Mystique 2pc

Free shipping on orders over $29.99

$18.37

$ 8 .99 $8.99

In Stock
  • Kit Includes: 2x Rack and Pinion Tie Rod Boots & Bellows
  • Fits: Specific Models - Check Fitment Chart and Product Description for Accurate Information
  • Steering boot is made of high quality rubber material.It is in good use condition.Helps prevent dirt, water, and debris from getting inside and damaging the steering rack. Protect the steering rack from damage.
  • The product has undergone rubber resistance to ozone aging, sediment impact, high and low temperatures, and fatigue tests to ensure the quality and stability of the product.
  • Warranty and Support -- Limited warranty and friendly customer service.



Product Description

ZK818980

111
Why Astarpro

OE Design-restore OE performance, handing and ride

Maximum Coverage-Convenient solution, complete repair, application specific

Quality Innovation-Re-engineered by OE defect, keep maximum fixation

Package Includes:

  • 2 x Rack And Pinion Bellows - 103-2897
  • Spectrum Analyzing
  • Salt Spraying Testing
  • Three-coordinate Measuring
  • Magnetic Flaw Detection
  • Rubber Oxidation Testing
  • Hardness Testing
  • Pull-out Force Testing
  • Endurance Testing

Fitment:

  • Replacement for 1994-1998 Audi Cabriolet
  • Replacement for 2001-2009 Ford Escape
  • Replacement for 2001-2009 Mazda Tribute
  • Replacement for 2005-2009 Mercury Mariner
  • Replacement for 1995-2000 Mercury Mystique
55555

11111

Qualified Product

High strength patented multi-lip locking boot and Labor Saver hardware included for quick easy install. Easy-snap locking pin securely locks the ball joint.

22222

Pre-locked Thread

Thread lock is pre-applied on inner tie rods, removing the need of applying it and reducing the time of installing the product.

33333

Longer Wrench Flat

Tie rods designed with longer wrench flats that provide a larger area for using a wrench which eases installation.

44444

Greaseable socket

Pre-greased ball joint with Grease fitting allowing lubricant to flush contaminants and can extend service life.

Steering Tie Rod End should be checked and replaced when you encounter the following problems:

ZK6541 BALL JOINT

Steering Wheel Vibrations

When the Steering Tie Rod End become excessively worn, it will make wheel shimmy, which may cause vibrations felt in the wheel.The intensity of the vibrations will increase as you step on the accelerator pedal to go faster.

ZK6541 BALL JOINTS

Clunking Noises

If Steering Tie Rod End develop excessive play or looseness, this can cause them to knock during takeoff, or when the vehicle is traveling over rough terrain. The clunking sound will continuously get louder as the component wears or until it eventually breaks.

Steering wandering

Steering Wandering

Excessively worn Steering Tie Rod End can cause the vehicle’s steering alignment to shift, which may cause the steering to pull to the left or right when traveling down the road.


Martin
Reviewed in the United States on April 28, 2024
These r very cheap but u get what u pay for the little part that holds the line for the power steering fluid it falls off