Shopping Cart

Your cart is empty.

Your cart is empty.

AURSINC Filter Attenuator RF Demo Kit NanoVNA RF Tester Board&SMA Calibration Kits Test and 2 pcs

Free shipping on orders over $29.99

$32.00

$ 14 .99 $14.99

In Stock
  • [NanoVNA RF Tester Board] The RF Demo Kit is a NanoVNA RF test board independently designed by BH5HNU, with a size of 10*10cm / 3.94*3.94 inch. The demo calibration board for evaluating and learning nanaovna vector network analyzer, antenna analyzer test calibration learning, making sure your setup is working
  • [NanoVNA RF Tester Board] This RF Demo Kit is integrated with 18 functional modules. Can be used to measure 30MHz short wave low-pass-filter LPF, 100MHz FM high-pass filter HPF, 433MHz commonly used SAW band pass filter BPF, 6.5MHz ceramic trap BSFtt
  • [NanoVNA RF Tester Board] The test parameters of the 18 patterns of the test board are described as follows. Two steps must be performed before testing: Step 1. Connect the two 20CM SMA to IPEX adapter cables to the NanoVNA-F machine. Step 2. Recalibrate the machine using the 13 Short, 14 Open, 15 Load, and 16 Thru circuits on the test board, and save the parameters to SAVE 0
  • [SMA Calibration Kits Test and 2 pcs] Frequency: DC to 3GHz. Connector: SMA male for Short and Load. Material: Copper, Shape: Circle. Inpedance: 50 Ohm. VSWR: less than 1.1
  • [SMA Calibration Kits Test and 2 pcs] This Calibration kits can use to calibrate Vector Network Analyzer, like Nanovna, Nanovna-H, Nanovna-h4, Nanovna SAA-2N, Nanovna F, mini1300, PS100 and so on


[NanoVNA RF Tester Board] package list: 1x PCB RF tester board, 2 x 20cm U.FL connectors (Be aware the connectors on the test cables that connect to the PCB are only good for a hand-full of connection/disconnection cycles before they break) [SMA Calibration Kits Test and 2 pcs] package list: 1x Open kit, 1x Short kit, 1x Load kit, 1x Male to Male Connector, 1x Female to Female Connector, 2x SMA Male to Male Coax Cable 0.98Ft


Recommended Products