Your cart is empty.
Your cart is empty.Product Description
Front Bumper Protector Brush Grille Guard
Get real front bumper protection for your vehicle! These front bumper guards adds style and toughness to the car, making clear that it will stand its ground and protect your original plastic bumper from accidental scratches and dings caused by minor rear collisions with a shopping cart or a careless driver on a parking lot.
Item specifics
- Materials: Stainless Steel
- Surface Finish: Polished
- Piping Diameter: 1.5" OD
Specifics and Features:
- Easy Bolt-In Application
- Rubber Padding to Minimize Minor Impacts
- Pre-Drilled Holes for Front Mounted Fog Lights
- Trimming of Bottom Plastic Liner may be Required
- Non Abrasive Wax Recommended to Protect Finish
- 03-08 Honda Pilot
Phen S. Ing
Reviewed in the United States on November 21, 2022
It is good. my wife does not like because it looks bigger, especially the left and the right portion over the head light. I am okay with with it.
Mark Phillips
Reviewed in the United States on April 14, 2021
Didn't like the fact it came with no instructions. Other than that, I like!
Steven swisher
Reviewed in the United States on February 22, 2019
This thing was darn near impossible to install. The directions (or so they were called) were not helpful at all. Barely readable due to poor printing quality and did not give any detail. We ended up having to use a drill to make some holes bigger and hammering in the bolts. Also the paint is low quality being we just hund a lump on it during installation and it scratched bad. One installed, it was crooked being higher on the driver side than the passenger.Now that's its installed, I do like it. But I would not recommend due to the near impossible assembly and installation.
Jeremy Brenner
Reviewed in the United States on April 21, 2019
I consider myself to be very competent with my mechanical abilities and this was a nightmare. Some of the vehicles underside guards needed to be cut to expose frame hardware. This is not a major task. New, longer metric hardware was needed to mount to the frame in four of the six contact points. Brackets for the guard had to be bent to fit. Directions only showed where to install which bolt but were so grainy that they were unreadable. I had to lay out the hardware and do a physical count to know which bolts were which. I was not able to use the side light guards as they obstruct the lights so I only used the center guard similar to law enforcement vehicles. I wouldn't recommend this but there wasn't much else on the market for under $300. It looks good but you better have some good tools and mechanical skills.
Recommended Products
$240.00
$ 99 .00 $99.00
$512.79
$ 99 .00 $99.00