Your cart is empty.
Your cart is empty.Product Description
Front Bumper Protector Brush Grille Guard
Get real front bumper protection for your vehicle! These front bumper guards adds style and toughness to the car, making clear that it will stand its ground and protect your original plastic bumper from accidental scratches and dings caused by minor rear collisions with a shopping cart or a careless driver on a parking lot.
Item specifics
- Materials: Mild Steel
- Surface Finish: Powder Coated
- Piping Diameter: 1.5" OD
Specifics and Features:
- Easy Bolt-In Application
- Rubber Padding to Minimize Minor Impacts
- Pre-Drilled Holes for Front Mounted Fog Lights
- Trimming of Bottom Plastic Liner may be Required
- Non Abrasive Wax Recommended to Protect Finish
- 11-16 Jeep Grand Cherokee
William K Geller
Reviewed in the United States on September 6, 2024
Bought this for my wife’s Grand Cherokee and it looks great. The instructions were less than helpful, 6 total and only two said anything close to an instruction for putting on the rig.
Green
Reviewed in the United States on June 8, 2024
The product came well wrapped in sheet foam inside a heavily abused DNA Motoring box. The instructions were less than expected but provided enough information to figure it out. Installation took about an hour by myself with basic hand tools without having to trim anything.Overall it's about what I expected. I just got my wife's 2015 Jeep back from the body shop after it took three (3!!!) Canadian Geese dead center. My insurance company approved over $6300 in damages and I still had to cover a few things to keep the cheap Chinese stuff off. If this had been on there the damage would have been substantially less if any at all. We have deer all around us so I want an even chance. Pretty good odds against shopping carts and unleashed children, 50/50 against a small blacktail and not so overbuilt that it can take on a Bison in Yellowstone.
Claudia
Reviewed in the United States on January 2, 2024
Wife hit a dear guard did its job.
DAVD82
Reviewed in the United States on June 5, 2021
We used this on our 2016 Jeep Grand Cherokee. It’s solid and well built, but looks a little awkward with how much space is between the brush guard and the grill. It would be nicer if it didn’t stick our quite as far.
Jacob M.
Reviewed in the United States on February 7, 2020
The good:It looks good, feels like gaurd it self will do the job. I knew it was not a HD gaurd when i bought it...instructions were beyond useless.required required cutting the plastic gaurd on the bottom of jeep. Took more time and tools to install this gaurd, than when i put a third gen. Dodge pickup grill gaurd on a second gen so be aware. Used some extra washers i had around to install it to fill punchouts better.The ugly, the factory stamped brackets are terribly weak and allow the grill gaurd to get wiggled nearly 2 inches back and forth so beware. It'll take a hour or so of weld time to do what should have been done from the get go. It will need a 2 inch by 3/16 flat iron to stop movement.After driving it shakes at every bump. Related at 2 stars...
Ben W.
Reviewed in the United States on April 22, 2020
Directions show you nothing, thought it mounted where the tow hooks go but it doesn't, I have no clue where this thing mounts up to, I took the whole front end apart to figure it out. Messaged the seller to get some kind of information. If anyone can help please email me if you can. Bward024@gmail.com thank you!
Customer
Reviewed in the United States on February 11, 2018
I put this grill guard on my wife’s 2015 Grand Cherokee. It only took about two hours. Perfect fit without any modifications except to the lower balance under the Jeep. Comes with stainless fasteners for top so rust won’t be an issue. The LED lights did not come with it.
Matthew McLeod
Reviewed in the United States on December 12, 2017
Looks great and very easy to install.
Recommended Products
$349.99
$ 99 .00 $99.00
$870.00
$ 99 .00 $99.00