Your cart is empty.
Your cart is empty.Product Description
-
ANNKUT COUCH RISERS
-
ANNKUT FURNITURE RISERS
-
ANNKUT BED RISERS
The Bald Bodybuilder + Designer Reviews
Reviewed in the United States on May 6, 2025
These are heavy duty risers. I got these to put in my living room to raise up my couch because I’m a tall dude at 6’3” antenna fall down flat onto the couch! LOL please help me out with 4 inches extra - and for me that’s awesome! The plastic is a tough polymer, I believe it’s made of polypropylene, and vendor says it supports up to 4000 lbs but I roughly need it for about 250 lbs and it’s doing his job well so far. It’s been a week since I got these but if there’s any change I’ll let you know. Check out my picture and video I’m including here soon. For all the above features I’m giving this a 5 out of five. It does what it say it does and it is durable.
Mike Colla
Reviewed in the United States on May 27, 2025
Worked well as 3” riser, not for the 4.3”. I remove top piece and was high enough for my needs.
NSFab
Reviewed in the United States on May 21, 2025
Raised an Ikea small couch in my office that was a little TOO low. The risers are super sturdy and have a textured surface so the couch doesn't slide off of them, even with hard sitting on the couch. Raised the couch to the right height. They are pretty straight forward to use, just be sure to measure the feet of your couch to get the correct size. Comes with floor protector pads as well.
Christopher I.
Reviewed in the United States on May 21, 2025
These are a great set of tough, robust, “modular” furniture risers. They allow for adjusted height, so you can stack them tall for full-height risers or adjust them if you just need a slight height adjustments, or just need to get your piece of furniture a hair off the ground. They’ve been great so far for the couch! Recommended.
JellyBeans
Reviewed in the United States on May 20, 2025
I have a dresser with very short legs so it's so difficult to clean under it. I decided to they these risers to raise it above the ground but was not sure if these will hold the weight of big wooden dresser. These risers are made of heavy duty plastic that holds weight pretty well. What I like the most about these come in removable section to adjust the height. One section from each set could be removed if you want less height. I used both the pieces because I wanted to give a good lift to the dresser so cleaning under it becomes easier. These risers come with a non slip rubber base and they stack very well. The two side elevated edges on the top section helps the furniture legs from slipping.These risers are so easy to install and are a pocket friendly solution to left any furniture like sofa, table or chair. I got the 3 inch risers for the dresser and it works just fine.
northwest coast
Reviewed in the United States on April 28, 2025
I needed larger risers as my headboard's feet are 3 inch square and these can accommodate such a size. They are well made and allow you to stack for one, two, or 3 in risers. I was actually trying to do a 6-inch rise as I only needed to raise my headboard's two legs. I need to sleep at an angle so my sinuses can drain without increasing my blood pressure. I mistakenly thought I could just use two sets under each foot. They don't exactly snap together, although they do sit nicely together with the dotted sides facing each other as long as you turn them so the lips and gaps line up. But they don't snap tight. I used one of the foam squares in between the two sets, and it is holding up just fine, and hasn't shifted or moved after a week of sleeping. But if you would feel better having a tightly snapped 6-in riser, look for a different set that is designed to accommodate greater lift heights.
Alva
Reviewed in the United States on April 25, 2025
There was no paperwork included other than the sticker on the box. I am not sure if the foam pads should go on top of the riser or on the floor below it, however, it fits perfectly within the top ridges of each piece. One of my foam pads was bent in the box. Each 2 7/8” riser comes in three pieces. The bottom base is made of a flexible type of plastic. This base is required. There are two other pieces that can fit in the base alone or on top of each other to come up to just under 3” in height. Each piece used alone with the base brings it to 1.5” high. These pieces are made of a hard plastic. The only difference is that there is a full ridge around one piece, and the other piece only has a ridge on one corner, so if your furniture leg is wider than three inches, it could fit by hanging over the other corner a little. They don't stack with the full rim on top. Overall, they appear very sturdy.Unfortunately, they didn’t work for my sofa because the legs have a plastic knob on the bottom of each, preventing it from sitting firmly on the riser. I do not want to remove those, because as you can see from the ottoman, they are not very attractive for this application anyway. Perhaps something with black legs would work better. In an attempt to find a use for them, though overkill, I used them under my sewing table to raise it closer to the other, which is risen by an older set of Annkut risers.
Martin
Reviewed in the United States on April 20, 2025
Hello Fellow Amazon Users..From my recent delivery of the Heavy Duty Furniture Risers that came from the ANNKUT Amazon store. I would like to say for the size of these items they worked perfect for me. I have three fur babies that range in different hair styles and are shedding their winter coats and i do depend on 2 robot vacuums to do the cleaning. I’ve decided to use these furniture risers to lift up my 72 inch entertainment center to allow enough clearance for the robot vacuums to get under this hard to reach space to clean up that mess. I’ve even found toys that they lost down there as well. I did have to use the full 3 inch risers to help lift it enough to allow the LIDAR sensor to gain clearance. I do find it very cool that the way they are designed that they lock into place to make sure they don’t come apart. I did push the entertainment center with these risers underneath to see that they do grip to the floor surface really well. I’ll never know if they do support up to 4000 LBS as I’m sure my entertainment center weights a fraction of that. I do appreciate them allowing me to review this item.
Recommended Products