Your cart is empty.
Your cart is empty.Product Description
Blacksmith G2 Guillotine Tool for Precision Fullering & Tennoning
- Work on Round or Square shoulders with Flat Dies
- Completely ambidextrious for right or left handed operation and can be set to stop from front or rear of the guillotine dies on either side
- Knife blades comes complete with two sets of dies. Dies are 1/2 " thick X 2 1/2 " wide One radius set and one flat set of dies.
WIDE APPLICATION
Blacksmith leaves
Cat tails
Candle Cups
J. Buckner
Reviewed in the United States on January 20, 2025
The tool seems pretty good, but the plates that you put in it at super soft. Used it once and already the strike plate is deformed. May try to fab some better ones out of spring steel.
Richard Blankenship
Reviewed in the United States on March 27, 2023
I had to make some adjustments to fit it in my anvil. But after that it worked. It did take some damage from striking which I didn’t expect. I’m sure it will still work for some smaller stuff but I would not recommend trying to make damascus with it.
Chris Hennessy
Reviewed in the United States on February 10, 2023
I would hard face the dies or get some better steel. After just a couple hammer blows it was already mushrooming over.
Recommended Products