Your cart is empty.
Your cart is empty. Bohning’s Blazer Nock fits Standard Diameter arrow shafts with an ID of .246” (commonly known as S-Nocks or 6.5mm shafts). This Nock will fit all Standard Carbon arrow shaft sizes. The Blazer Nock features a Raised Index and a Double-lock throat. Each Blazer nock weighs an average of 9.0 grains (583mg).
Tech tip: for easier insertion and indexing, apply a small amount of Bohning’s Tex-Tite or Seal-Tite Wax to the nock shank.
NOT ALL BRANDS OF NOCKS ARE CREATED EQUAL
At Bohning, every nock style must pass the following steps before introduction to the market:
1. Computer simulations identify potential weak points.
2. Destructive testing methods expose possible design flaws or material defects.
3. Accelerated life cycle testing using a custom-built bow is performed at kinetic energy levels exceeding 110 ft-lbs (nearly twice that of most hunting bows). A single nock must withstand over 1000 shots or it goes back to step 1.
Proudly manufactured at the Bohning Factory in Lake City, Michigan, United States.
MJRPHOTOdotNET
Reviewed in the United States on July 2, 2019
As described
clint
Reviewed in the United States on May 7, 2019
They're good nocks for .244 inside diameter arrows.
Mikel
Reviewed in the United States on February 24, 2016
They fit my shafts, they fit my center serving, they fit my needs.
Klem
Reviewed in the United States on August 7, 2012
I got these as replacements for some broken nocks . I contacted victory who made my arrows and they use these same nocks with the vforce arrows. Fit great.
Recommended Products
