Your cart is empty.
Your cart is empty.Product Description
Quick connect lamp plug
Polarized blades
Shorten or repair your lamp cord with this easy to use quick connect plug
- Accepts SPT-2
- 18/2 lamp cord
- 6 amps - 125 volts
- UL listed
About B&P Lamp Supply
We've been in the wholesale and retail lighting industry for over 65 years. We are committed to designing and selling quality lamp parts serving residential, commercial and lighting designers.
Mark
Reviewed in the United States on March 8, 2025
Easy install.
Karl Rodey
Reviewed in the United States on February 15, 2025
Had my neighbor who is an electrician install this plug, bad news it must have been a bad product the circuit blew plus the plug also blew out within the plastic housing Beware
Diane M.
Reviewed in the United States on December 22, 2024
Poor design, no instructions, did not work. I ended up throwing it I. The trash and purchasing a full cord and plug at Lowes
MalvernBound
Reviewed in the United States on October 3, 2024
I was suspect of this based on many sub-par reviews. My experience however was excellent. The plug worked perfectly as advertised. I followed exact instructions provided by other reviewers since none came with the product itself (which is ridiculous).
don
Reviewed in the United States on October 28, 2024
Very easy to use.
Leslie Collup
Reviewed in the United States on February 23, 2023
This product comes with no instructions and since this is Amazon and not a hardware store, it should. You simply cut the end of the cord flush, DO NOT expose the wires, leave the insulation intact. There are 2 parts: the prongs and the base. The prongs pull apart to allow for insertion of the cord into the opening in the center. After you've cut the cord flush, FIRST feed the cord through the bottom of the base piece and SECOND, with the prongs spread outward, feed the cord into the center opening of the prongs piece. Push the cord all of the way in, until it can't go any further. Squeeze the prongs back to center. The metal will penetrate the insulation to make contact with the wires and create your circuit. I tested the prongs first, to make sure it worked and then pushed the prong piece into the base as it's not so easy to remove once you'ce inserted it into the base. So easy!
Mark Moore
Reviewed in the United States on March 13, 2022
There were no instructions but with common sense it was easy. I found it worked just as expected. Quick, easy, just a little costly. That being said I’d buy it again.
Brian M
Reviewed in the United States on July 15, 2021
These were easy to install and look very much like the original plug on my lamps. Just be sure you get the metal contact points fully seated in the cord for a good connection.
Recommended Products