Your cart is empty.
Your cart is empty.Product Description
Bruce & Shark 4x Motorcycle Rubber Gas Tank Pad Traction Side Fuel Gas Knee Grip Protector, Gas Tank Protector Motorcycle Tank Pad Fit for Kawasaki EX400 Ninja 400 2018 2019 2020
FITMENT:
Fit for Kawasaki Ninja 400 2018-2020
PACKAGE INCLUDES:
4-Piece Kit
Please check out the size and product to confirm the compatibility before purchasing.
Steps Recommendations:
-Please use detergent to clean the surface of the target before stick it on.
(Clean the part thoroughly from grease/wax/polish. Use IPA cleaner if possible.)
-You can peel off the red or white surface and stick it on the fuel tank, then peel off the other side of the adhesive and put the pad on it,
or you can put the adhesive on the pad first, and then stick the pad to the fuel tank.
-Allow 12 hours for the pad to set in. Do not ride straight away.
FEATURES:
Increased vehicle control. More contact between the vehicle and rider/driver.
High quality rubber material stands up to Sun/Wind/Rain stays pliable in the cold.
Honeycomb profile traction bumps. Designed to wear down and be replaced like a tire.
Pre-molded with rounded edges that resist peeling.
Super strong peel-and-stick clear adhesive, just peel off the red surface and white surface.
High strength adhesive holds up longer than the competition.
Adhesives(Double-sided) are separated from pads.
Can easily be custom cut with a knife or scissors.
Instruction NOT included.
NOTE:
Please check out the size and product fits your motorcycle or not before you purchase.
Please use detergent to clean the surface of the target before stick it on.
Please check out the size and product to confirm the compatibility before purchasing.
Easy to install, you could directly replace it, professional installtion is recomendated.
Please check the product images, what you receive is the same as the pictures, Please allow 1-3mm difference due to manual measurement.
Ardith s.
Reviewed in the United States on March 10, 2025
Great grip. Used on my mt07 so great versatility too
nam
Reviewed in the United States on January 20, 2025
Some how it shrunk a lot in the summer heat revealing the sticky adhesive. Would not buy again.
Landon
Reviewed in the United States on May 26, 2024
These are so cheap- the adhesive layer required me to align it with the tank pads and then put them on. This led to clear adhesive being visible sticking out, and requires trimming and it’s VERY annoying. They could have just connected it to the pad and have you remove only one sticky side to put it on your bike. You know, like every other product out there that sticks to something… The lower narrow pieces were so hard to work with, I ended up just throwing them away. Don’t waste your money here and get the higher quality pads. The better quality ones don’t cut corners like these did and force you to stick an adhesive layer to the product itself AND your bike. Couldn’t recommend any less.
WhatDaDogDo?
Reviewed in the United States on January 16, 2024
Application was simple. I like the fact that the adhesive came unapplied. Though the adhesive was slightly too big. I had to make some trimmings. It’s very grippy and makes a huge difference cornering. Like all adhesives, let’s see how long it holds.
Brian Ashby
Reviewed in the United States on August 7, 2023
Great grip and good adhesive holding it in place through rain and excessive Texas heat. Very happy with product
JoAnna
Reviewed in the United States on June 6, 2023
When peeling first side of the double sided tape it kept stretching out, after multiple attempts to slowly peel away the backing, it was stretched too far for me to be able to use it.
Adam
Reviewed in the United States on June 4, 2022
Added this to my first bike and noticed an immediate difference in control and grip sitting on the bike. Leaning into the tighter turns there's plenty of grip to hold on with. Application is simple. Appearance isn't the greatest.
CJ Guerra
Reviewed in the United States on August 14, 2021
Bought this 12/30/2020 and received it near the end of January. Application was easy, but a little messy. You can definitely see how thick the adhesive strip is. Looks good from far, not so much up close. The grip it provides is great.The grip pad started separating from the adhesive strip after 6 months of use. I think it is due to the hot summer weather where I live (over 100°F / 38°C). I'm debating on buying a roll of 3M automotive tape to re-apply it, or just shell out for the TechSpec tank grips.
Recommended Products
$22.99
$ 11 .99 $11.99
$15.99
$ 7 .99 $7.99
$100.00
$ 47 .99 $47.99