Shopping Cart

Your cart is empty.

Your cart is empty.

Cable fix Black Single Mount Tie-Clips Lapel Lavalier Microphone Headworn Clips for holding lapel mic WL93 and SM93 microphones, fit for wire/wireless earbuds- Set of 20

Free shipping on orders over $29.99

$6.90

$ 2 .99 $2.99

In Stock

About this item

  • 20pcs total, fit for all lavalier microphone Cable
  • fit for wire/ wireless earbuds
  • only 20pcs clip
  • for holding lapel mics


fit for 2.0mm cable, fit for wire/ wireless earbuds


Kenneth J.
Reviewed in the United States on September 9, 2024
Have plenty of spears since they get lost
Joe Teixeira
Reviewed in the United States on December 21, 2024
My headset cable doesn't fit in these clips.
Hank
Reviewed in the United States on September 4, 2023
It works. What can I say?
Peter Sperico
Reviewed in the United States on September 13, 2023
If is basically a tiny clip if the wire is thick it will break.
Vickie Burgee
Reviewed in the United States on August 14, 2023
Will purchase from this Seller again
Wade posey
Reviewed in the United States on February 28, 2023
Work great and will order again
Russell Miller
Reviewed in the United States on February 2, 2023
The wire clip and retainer mechanism are for VERY small diameter wires only. When it says earbud, that is about the biggest diameter of a single side wire that you could use. I have a clip on my headset/microphone. The wire is not large, but larger than these clips. It is about the diameter of two single ear bud wires encased in a single sleeve. After breaking about 5 of each kind of clip, I realized it just had no give. The wire retainer clips are quite fragile. They won't take much bending and they snap off clean. My solution was to remove all high edges on my old clip (as the wire retainer was still working fine) and glue one of the small clips on the end of my old clip, so the teeth will still grab my shirt. Not ideal, but it worked. For the price, I couldn't have come up with a better solution...other than if it had fit my wire. But, I knew it was a gamble when I bought it. If the wire retainers were metal instead of plastic, it would have been able to bend and fit the wire.
Josh
Reviewed in the United States on September 25, 2020
As described. Thanks!