Your cart is empty.
Your cart is empty.Our carburetor mounting studs are made to be screwed into the intake with an Allen wrench. By installing studs into your intake you eliminate the common problem of pulling the threads out each time you reinstall the carb. The mounting kit comes with a set of 4 stainless steel studs and 4 locking flange nuts.
Doug S
Reviewed in the United States on November 21, 2024
After running out of options (i.e. 3.5" studs) decided to just bite the bullet and buy these because they state for 2" carb spacers". Have to admit was a bit skeptical because the description said they're 3-3/4" long so wasn't sure they were going to work as 3.5" studs were too short and didn't give any thread protrusion through the nut. Installed these today and they are the real deal. Also love the fact that they have hex sockets to tighten the stud in the intake manifold. Bottomline, if you have a 2" spacer these are the studs you need, don't waste your time on anything else.
d*****1
Reviewed in the United States on December 4, 2022
fit good, looks good, works good.
darron brammer
Reviewed in the United States on April 21, 2019
Great
julie stephenson
Reviewed in the United States on October 20, 2018
Drag car , They worked great loved the price !
Recommended Products
