Your cart is empty.
Your cart is empty. Replaces Tohatsu Carburetor Assembly Part OEM Number#:
3V2031002M, 3V2031332M, 3DP031000M, 3DP031330M
3V1031002M, 3V1031332M, 3DN031000M, 3DN031330M
Replaces Nissan Carburetor Assembly Part OEM Number#:
3V2-03100-2, 3V2-03133-2, 3DP-03100-0, 3DP-03133-0
3V1-03100-2, 3V1-03133-2, 3DN-03100-0, 3DN-03133-0
Applications:
This carburetor Assembly fits these Tohatsu Nissan 4-stroke outboard motors:
2014 MFS9.8A3
2014 NSF9.8A3
2013 MFS9.8A3
2013 NSF9.8A3
2012 MFS9.8A3
2012 NSF9.8A3
2011 MFS9.8A3
2011 NSF9.8A3
2010 MFS9.8A3
2010 NSF9.8A3
2009 MFS9.8A3
2009 NSF9.8A3
2006 MFS9.8A3
2006 NSF9.8A3
2004 MFS9.8A2
2004 NSF9.8A2
Andy N
Reviewed in the United States on April 7, 2025
Runs like a charm; excellent fit; near identical replacement. Don’t hesitate to purchase if you have a Tohatsu 8hp MFS8A3 outboard.
CT
Reviewed in the United States on April 14, 2025
The media could not be loaded.
Customer
Reviewed in the United States on September 25, 2024
Worked well
T. Peterson
Reviewed in the United States on March 5, 2024
Easy install. Easy minor adjustment to throttle rod.
Biggly
Reviewed in the United States on October 9, 2024
For being 1/3 the cost of OEM I didn't expect much but this carb works very well. Only slight adjustments needed to be made and the engine ran with the carb right out of the box. MY 2016 Tohatsu 9.8 didn't have the enrichment circut like this replacement but it works just fine. At least ln my motor I eliminated the plastic spacer to avoid needing to purchase a new gasket, which was stuck to my old carb. the single gasket on the intake right to the carb worked out perfectly for me.
kenn4545
Reviewed in the United States on June 6, 2023
Perfect replacement! Everything matched up and it works great! Just had to adjust the idle screw.. Very satisfied.
Kindle Customer
Reviewed in the United States on October 20, 2023
This carb is not jetted properly for Tohatsu 9.8, it’s way too rich. The motor loaded up badly and blew black smoke. Plugs were badly carbon fouled.
Dan Landsperger
Reviewed in the United States on September 2, 2022
This was a perfect replacement for my Tohatsu 9.8 A3 with one exception. I noticed the choke lever had less travel than with the original carb, but didn't think anything of it. Flash forward quite a few minutes of trying to start and I realize when tightened the carb down again the choke lever had no movement this time. The diameter butterfly is slightly larger than original and it was hitting and binding on the original plastic gasket on the air box side. I used a Dremel tool to enlarge the opening and the choke now worked fine. Still might take some adjustments, but in my humble opinion this was still a much easier option than rebuilding the original carb that started leaking fuel and was always kind if finicky to begin with. The job should take less than 30 minutes knowing about the diameter issue.
Recommended Products
