Your cart is empty.
Your cart is empty.Roller cam lobes are ground flat rather than tapered like a flat tappet cam; it is necessary to provide some means of holding the cam back to the rear of the engine. The thrust button rides between the front of the timing gear and the back of the front cover and can be shimmed for proper end play of the cam. COMP Cams has both the solid nylon button and the roller thrust bearing available for the ultimate in performance.
Jason Clarke
Reviewed in Canada on May 26, 2022
Exactly what I needed for my 383 stroker build non roller block
Herbert Gayle
Reviewed in the United States on March 1, 2018
Works good in al my roller engine build
Richard L. Misner
Reviewed in the United States on October 5, 2017
work great to keep the cam in place
Frank Schalk
Reviewed in the United States on March 7, 2016
this will be great right?
Psychomotors
Reviewed in the United States on April 22, 2015
Well made part.
33 Mercury
Reviewed in the United States on September 13, 2014
Part was good quality, but no instructions for use and I could not make it fit. It was too long and I could not see how it could not be shortened. I went to a speed shop and bought a Mr. Gasket part that I figured out how to make it work.
bradley hicks
Reviewed in the United States on May 28, 2014
excellant overall experience, everything came exactly as i was told, will purchase again with no hesitation in the future period
Recommended Products
$72.99
$ 34 .99 $34.99