Your cart is empty.
Your cart is empty.Product Description
Ball Bearing
The Flush Trim Router Bit is equipped with premium bearings, incorporating two distinct ball bearing roller guides at its tip.
Naco Coating
Naco coating produces cutting results of the highest quality and longevity, increase up to 3x life times compared to uncoated bits
Easy Template Routing & Smooth Cuts
The Flush Trim Router Bit features double ball bearings, which enable easy routing along templates and smooth cutting surface.
Water Monkey
Reviewed in the United States on March 16, 2025
So far, I have not had any of the issues other users have had with the bearing nut. I will say this is not a high quality bit. Meaning there are high end manufacturers of bits that make bits that will run much higher than this one. For the pattern cuts I was making I made sure I took it slow. I lowered the speed of the router, and took it easy.If you are trying to decide if you want to invest in compression bits, this may be a good way to test their functionality. This is a low priced bit that works well. I do find value in this bit.
Roy Wallin, Jr.
Reviewed in the United States on February 17, 2025
The bit worked quite well but lost the bearings and retainer screw on the first use. It was a miracle I found them (so small ). I think it would be wise to use a good loc-tight on this screw. Users beware of setting the cut depth low enough that this retainer screw is below your template.
John
Reviewed in the United States on December 14, 2024
Cuts very cleanly. I did notice a slight bit of play in the bearing, but upon use, it didn't seem to affect the bit's ability to follow a pattern. The spiral nature of the bit seems to make it a bit less aggressive which (in my opinion) makes it a bit easier control.
Patrick G.
Reviewed in the United States on November 6, 2024
Poor quality. Worked like a beaver for 3 seconds until the top shot off. Checked prior to usage, was no Allen key to tighten. Better options on Amazon than this.
Customer
Reviewed in the United States on November 5, 2024
First cut and the bearings and nut fell off
WhatAtooL
Reviewed in the United States on November 10, 2024
The media could not be loaded.
Dave Millman
Reviewed in the United States on October 29, 2024
I've used this on one project with a router table and 1/4" router. This bit gave clean cuts on both sides of the workpiece, cleaner than a straight-cut bit. The bearing tracked the template nicely. I haven't used it enough yet to see the difference between a compression bit and upcut or downcut spiral bits, it will be fun to try them all.
Milo
Reviewed in the United States on October 13, 2024
When you can't use a table router, naturally it's a handheld and a 1/4" is a good size for that. I have a cordless 1/4" router, and typically what I'd use it for is trimming the edge of boards that I couldn't take to the router table and this bit is great for that. It's nice and sharp and being a compression bit, makes clean cuts on both sides of the board, as long as you center it. It's got a 1 1/4" cutting length, and that's good for 3/4" boards which I often use for bookshelves. It's made from tungsten which is good for a bit. It also has a blue coating which they say helps with corrosion resistance, lubrication and extends bit life. It does make nice, clean cuts, and this is a really good price for a bit with all these characteristics. I'm pleased with its performance, and even the label on the little plastic case indicates what it is for easy identification which many brands do not. Totally pleased with this one.
Recommended Products
$25.20
$ 11 .99 $11.99