Your cart is empty.
Your cart is empty.This Control Devices SA25-1A060 ASME safety valve has a brass body, a 60 psi relief pressure, a 1/4 inch male NPT threaded inlet connection, and a stainless steel pull ring for manual pressure relief. The valve's brass body, brass valve seat, and the zinc plated steel spring resist corrosion and can be used in operating temperatures up to 400 F. The preset relief pressure is accurate to within +/- 3 percent and a silicon O-ring provides a leak-proof seal to within +/- 10 percent of the relief pressure. This safety valve is American Society of Mechanical Engineers (ASME) safety rated and displays the UV mark for pressure vessel safety valves. It also displays the NB mark for certification in accordance with NB-501, National Board Certification of Pressure Relief Devices. This safety valve has a 57. 7812 cubic feet per minute (CFM) flow rate and is suitable for pressure relief applications such as in home construction or industrial air compressors.
Mel
Reviewed in the United States on May 23, 2023
I ordered this to replace the factory 60# release valve. It releases at 43#. Exactly the same as the first one the company sent me. They fire each time at 43#, so the consistency of the units is there. However, I need the full capacity of the tank. 60# means 60#, and not 43#. If you need a unit like this I recommend trying another company.
Gerald Alston
Reviewed in the United States on September 11, 2022
Solid
Kirstenreading
Reviewed in the United States on January 13, 2022
Got this item and neither the original nor the replacement worked. always leaked air pressure.
JC
Reviewed in the United States on April 21, 2022
I could hand tighten about halfway but as soon as I use a wrench, and with little effort, the whole thing deforms.
lee hall
Reviewed in the United States on October 27, 2021
Pressurized a paint pot to 60 psi and it did not blow. Not to sure if I will take it above rated pressure to validate calibration
Recommended Products
