Shopping Cart

Your cart is empty.

Your cart is empty.

Criditpid MGB100 Wall Heater Blower Fan Kit for ProCom, Avenger MG and Bluegrass Living Ventless Space Heaters Over 10,000 BTU, Replacement ProCom MGB100 Heater Vent-Free Wall Heater Fan Blower Kit

5.0 Write Review
Free shipping on orders over $29.99

$39.99

$ 17 .99 $17.99

In Stock

About this item

  • ➤Compatibility: MGB100 Blower Fan Kit for all ProCom and Avenger MG Ventless Space Heaters over 10,000 BTU; Fits all Bluegrass Living Ventless Space Heaters over 10,000 BTU (2016 to Later). Fits for Procom blue flame or infrared vent-free wall heaters. Note: This space heater fan blower does not work with space heaters 10,000 BTUs and below.
  • ➤The MGB100 Blower Fan Kit Specifications : Size: 5 3/16'' x 5 5/8'' x 6 1/8'', Spacing of Screw Holes: 4 3/4'' x 5 3/4'', Power Cord Length: 51 3/4''. Standard 3-prong 120-Volt plug. Please Note: Please be sure to compare the dimensions listed with your original, to ensure proper fitment.
  • ➤ Premium Performance: Specifically designed for use with Procom vent-free space heaters with a BTU in excess of 10,000, this blower fan guarantees improved heat distribution throughout your home. The fan has a heat output of 10,000 BTU, is constructed of durable metal, equipped with an oxygen level control, automatic delay shutoff, a built-in timer, and can be used indoors and outdoors. Installs quickly and easily.
  • ➤AUTO/OFF/Manual Operation Mode: Installed switch installed on the heater blower is a three-position switch. Set the switch to 'MAN' for manual mode, allowing the fan to continuously run until the switch is returned to the OFF 'O' position'; Set the switch to 'AUTO' for the automatic mode, which will automatically cycle the blower on as the heater heats up and then off when the unit has cooled.
  • ➤Improve Whole Room Heating: The Procom heater MGB100 blower fan provides whisper-quiet operation, moving more air from the ventless heater, blowing heat toward the open space of the living room instead of rising upward, circulating heat through the room and helping to heat the room faster.


Specifications:

Dimensions of Fan: 5 3/16'' x 5 5/8'' x 6 1/8"

The spacing of screw holes: 4 3/4'' x 5 3/4''

Requires standard 120V household current

Two (2) Operating Modes: Thermostat and Manual

Thermostat Setting – Blower will cycle on and off automatically

Manual Setting - ON/OFF settings

Automatic sensor on blower is rated at 60℃ (140 F)


Compatibility:

➤ Works with all ProCom Vent-Free Space Heaters over 10,000 BTU

➤ Works with all Avenger MG Ventless Space Heaters over 10,000 BTU

➤ Works with all Bluegrass Living Ventless Space Heaters over 10,000 BTU (2016 to Later)



Note: Please double check the size of your original parts, and compare with ours to ensure proper fitment before ordering.