Your cart is empty.
Your cart is empty.Crown Automotive carries over 9600 unique quality replacement parts encompassing over 766,000 different applications for every model of Jeep produced since 1941.
Part Time Ninja
Reviewed in the United States on January 15, 2025
The oil slinger has to be pressed in, it will be tight. I used a regular propane torch to heat up the slinger only and lightly hammer it in with any metal pipe or large socket that fits over the inside outer lip. Do not over press it in or it will tear up the rubber seal.
Alex
Reviewed in the United States on January 7, 2024
Happy to have a replacement part for my jeep xj 96 which has a np231. The inner diameter was too small so had to dremel it. Just grind it to the point it barely slides past the splines. Hammer it on til it’s pressed against the washer behind it. This part isn’t really necessary if you’re using your XJ on the road. It’s nice to have as it retains the OEM look which matters to me. Gets 4 star because there’s a replacement but you need to do a bit of grinding to have it perfectly press on
Chaidez
Reviewed in the United States on May 30, 2023
Installed on my 1998 Jeep Wrangler but I had to enlarge the inner diameter with a Dremel and the installation required some light love taps to have it sit flush.All in all, got the job done.
Steven
Reviewed in the United States on August 26, 2021
I tried it on my NP231 but it doesn't fit well, you're better off running it without the dust shield. Or just getting an SYE
Theodore Brown
Reviewed in the United States on March 21, 2021
I installed this on my 1996 Jeep Cherokee XJ and the fitment was the same as the oem unit that I had removed to replace the leaking rear output shaft seal. This unit was identical in size and the thickness of the steel to that of the factory unit I had removed. I would recomment this product to anyone.
John Crane
Reviewed in the United States on May 30, 2020
Didn't want to go on an NP242 output shaft, or at least I didn't want to beat my shaft hard enough to make it fit.. I had to file it down to make it work, and think I went just a little too far as it's a bit loose now. To make it worse, it was all for naught as the seal looked good, so guess my leak is from somewhere else.
Kenny
Reviewed in the United States on December 4, 2020
gift for someone
Amanda
Reviewed in the United States on October 23, 2018
Works as described. Fairly easy to install. I heavily recommend a deal puller to remove the old one.
Recommended Products
$145.45
$ 71 .99 $71.99
$136.99
$ 60 .99 $60.99