Your cart is empty.
Your cart is empty.Crown Automotive carries over 9600 unique quality replacement parts encompassing over 766,000 different applications for every model of Jeep produced since 1941.
Greg
Reviewed in the United States on January 4, 2020
It would not fit on speedometer drive due to the crimp being made to small
Collin
Reviewed in the United States on November 27, 2019
Not a cheap piece of plastic and speedometer reads out correctly now. Crown Automotive has best selection of OEM parts.
Just Me
Reviewed in the United States on June 15, 2018
The square input socket on the end of the gear was too small. Before the gear was seated into the speed sensor it stuck. Trying to get it out destroyed pulled the speed sensor shaft out. It ruined the speed sensor forcing me to buy another speed sensor. I bought a gear from someone else. Some else has reported the same defect. Don't take a chance on getting a defective part....don't buy this brand.
Christopher Simons
Reviewed in the United States on November 4, 2017
Arrived on time. Worked as described. That says everything.
Ryan
Reviewed in the United States on March 10, 2015
Works good! just make sure it meshs with the worm gear, also Replace the o-ring while installing as the old one will be hardened and brittle.
Marsh
Reviewed in the United States on August 10, 2014
Finally found the problem and it wasn't electrical at all, but rather this gear. Worked like a charm with a 5 minute fix and my speedometer and cruse control now work :-)
Pain
Reviewed in the United States on July 1, 2014
Works good
gary
Reviewed in the United States on August 28, 2013
I run 33x10.5 on my jeep and this gear puts my speed to within 1 MPH at 56 MPH. At lower speeds I have checked it on both GPS and on-base speed radar and between 15 and 45 MPH I am dead on.
Recommended Products