Your cart is empty.
Your cart is empty.jesse padilla
Reviewed in the United States on May 22, 2025
Quick delivery
Ace
Reviewed in the United States on August 1, 2024
Build quality is somewhat flimsy. However, they get the job done.
MotorMan
Reviewed in the United States on November 10, 2024
Great value for your money, lights work exactly as I thought and needed them to work. Very bright and easy to install. Just make sure you uook them up to 12-24 VDC
fiacost
Reviewed in Canada on June 23, 2023
I use them in my workshop powered by a lipo battery I use on my remote controlled airplanes. You can use anything from 3 cell to 6 cells; the higher the voltage the brightest the light. It takes over 4 hours of constant usage connected to a 4500C 4 cells battery, plenty of time.....
Shaofu Chang
Reviewed in the United States on September 6, 2022
Its lightweight, disassembly revealed the presence of hollow space on the heatsink base, lack of thermal transfer tape between the LED board and the heatsink, and the presence of a boost regulator circuit on the far end of the board opposite of the power inlet section. The LED board heats up rather quickly, while the metal base is barely lukewarm, so the thermal bottleneck will be the demise of the LEDs, this is fairly easy fix with thermal tape (again, huge cost offset). Despite it being written as 12/24V it doesn't benefit going higher than 12V. The regulator will track around 11.5V or so and start folding past 12.5VInput Voltage/Input current/Operating wattage09.0/0.07/0.63W10.0/0.24/2.40W11.0/0.45/4.95W12.0/0.63/7.56W13.0/0.57/7.41W14.0/0.53/7.42W15.0/0.49/7.35W16.0/0.45/7.20W17.0/0.42/7.14WThis product has 108 LEDs, 36 pairs of three in series without balancing resistors. by lowering the voltage input varying brightness is observed between banks indicating mismatch of LEDs, the ones that shine the brightest at low voltages are the ones likely to burn out first. I'd use these as temporary lights and not really fitting for permanent installs unless you make some improvements, otherwise you'll have to learn to like replacing stuff.The light has a protection diode from reverse polarity, that's a plus.
larry grover
Reviewed in the United States on June 9, 2022
These are great had issues with 2 of them but sellers took care of it quickly
Customer in Cleveland OH
Reviewed in the United States on April 18, 2022
Perfect size for what I needed in my cnc lathe. I set up a voltage buck to run this light at 18 volts. 24 volts too bright...12 volts bright but not what I wanted...18 volts was my sweet spot. On the down side...its light built...not a real sturdy construction...but I mean! For the dollar value it is fine!
CoastalGuy
Reviewed in the United States on August 14, 2021
I needed a new light for my boat cabin, and the original incandescent was in a poor place and very dim. Replaced with one of these lights and soooo much better. The included mount clips were easy to place and the integrated rocker switch is convenient to turn it on and off.
Tom
Reviewed in the United States on November 21, 2021
Perfect for adding light to my snowmobile trailer. super easy to mount and hook up, and the lights are extremely bright!
Recommended Products