Your cart is empty.
Your cart is empty. for 2 Bearing Line Roller System
Disassembling the line roller section, the genuine parts are in the order shown in the photo.(Image #2)
Replace the stock parts with line roller bearings and roller washers, referring to the photo.(Image #3)
When reassembling the line roller, it is easier to work by putting the parts in order on the bail side as shown in the photo.(Image #4)
Finally, squeeze the screws to complete the process.
for 2 Bearing Handle Knob System
Remove the handle knob cap using a genuine DAIWA tool (sold separately).
Replace the black plastic collar inside the handle knob with a handle knob bearing.
The number of washers depends on the reel, so please install them as they were originally.
If the handle knob does not turn, please remove one washer.(Image #5)
One Point Advice
The black plastic color of the handle knob, but it may be hard to remove because it is deep in the knob.(Image #6)
A handle knob cap remover is very useful in these situations.
Parts located in deep places can be easily removed.(Image #7)
topgun
Reviewed in Japan on January 18, 2025
8000Hに組み込みました。このベアリングが悪い訳じゃないですが体感できるほどの違いは無いかも！樹脂でもグリスがしっかり入ってれば大丈夫かなーYouTuberの方が言ってるようなラインローラーでの不都合は無かったです。ハンドルノブは中のネジを締めすぎると回転が悪くなります。程々の調整が必要でした。
Recommended Products
