Your cart is empty.
Your cart is empty.Bump Stops are a critical part of your vehicle's suspension - they prevent damaging over-compression and eliminate harsh bottoming of the suspension. Daystar's Bump Stops are designed and tested under the most rigorous conditions imaginable to deliver positive stopping power without deflecting. Daystar bumpstops are available in a variety of application-specific and universal applications - from low-profile to bullet-shaped to pyramid inchcompetition-style, inch Daystar Bump Stops are used and abused worldwide. Daystar EVS Foam Bump Stops are the next generation in bump stop technology. Daystar EVS Foam stops use a proprietary Microcellular Foam material that provides a true progressive spring rate. Rather than being strictly a limiter, EVS Foam is designed to be an active part of the suspension with a rate that increases as the material compresses. Great for everything from racing to recreational use, the only limitation to Daystar EVS Foam is your imagination.
Customer
Reviewed in the United States on September 11, 2021
SO I was looking at factory style replacement for my 1997 k1500 as were installing at 6" liftthese were about $20 for the set. The factory replacement which has to have the side shaved with the lift kit was $52 for one. These are about 1/2 an inch sorter than the factory ones but seem to work quite nicely.No shaving needed. Ill probably forget to post pictures.
Jesse Smigielski
Reviewed in the United States on December 16, 2021
I bought this for my lift kit. When they came in, they are actually smaller then the factory bump stops. Very disappointed. Don't waste your money
John R
Reviewed in the United States on June 7, 2018
Perfect replacement fit for some old rotted out parts
Yota King
Reviewed in the United States on July 10, 2017
The nuts they bring don't fit made me strip the bolt on the bump stop
TJM Foundation
Reviewed in the United States on March 23, 2017
Exactly what I needed. Packaged well. Just as described
TERRY HARVEY
Reviewed in the United States on March 31, 2015
are as listed but not what i needed. my bad, should have looked at size better
RDZ M.
Reviewed in the United States on February 16, 2015
did not fit my truck
Nick
Reviewed in the United States on April 30, 2015
Installed on 04 GMC Canyon z85. I cut the first step on the end off to make them close to factory size since I don't have any lift on my truck. I then cut three notches out of the larger ring so that they would fit in the mounting location. After this I was able to bolt them in place using an open end 14 mm wrench. I doubt they will ever need to be replaced again.
Recommended Products
$11.99
$ 5 .99 $5.99