Your cart is empty.
Your cart is empty.DEA Products DEA A6009 Drive Shaft Center Support
Marlon
Reviewed in the United States on April 4, 2023
Buen artículo 👍
Chris
Reviewed in the United States on March 24, 2021
I have never changed a Carrier Bearing before but just based on some of the details I noticed while installing this one (rubber was not scored [cut] correctly near the bearing, bearing came apart while installing [but was able to be pressed back on and seems to be good so far) I would say that this bearing is good quality for the very modest price they are currently going for (around ~$20 compared to the much higher cost at brick and mortar repair stores or even other online sellers). I put it on over a weekend after doing my u-joints and noticing that my old bearing rubber donut was in rough shape and would warp my driveshaft it not replaced. Pretty easy install, took about a half hour once I got to working on it, you can either take it to a person with a press (in which case it may last a lil bit longer) or could probably get away with hammer+pipe method. I heard a slight squeaking the following weekend while driving through town, but it was hard to tell it this was the culprit or if it may have been the new u-joints, or maybe something different altogether (I drive a 2 decade old frontier, with the rust and wear, who knows...). If something happens Ill update this post but so far I am satisfied with my purchase. 4 stars because it is good bang for buck.
D.J.
Reviewed in the United States on June 28, 2020
Worked, but bearing seal came off easily, and had to press it back on again. So far it has stayed together.
justin
Reviewed in the United States on September 29, 2018
Fit as it should comparable to oem
Richard Bourque
Reviewed in the United States on September 9, 2016
fit great.easy install.performs as expected. delivered before promised. i recomend this company...
Trixxer13
Reviewed in the United States on July 30, 2016
Fit was not exactly the same as OEM, but it works well enough. I am not too sure about the durability of the item, and only time will tell.
kyle
Reviewed in the United States on December 16, 2016
I was sent three bearings, all with damage. The first actually had a bad bearing that was entombed in the rubber. The bearing was so bad that got SUPER HOT after about 5 mins in the truck and caused the driveshaft to get hot. The second bearing i ordered had a flutter issue that was as bad as the annihilated bearing it was supposed to replace. the driveshaft just bounced around and vibrated horribly. Also, i confirmed this was not an out-of-alignment driveshaft since you have to split it to install this. I had the DS installed in the correct orientation. The third bearing had dents in the dist shield lips. I let this go since i needed the truck back on the road and i was tired of pulling it over and over again. The third bearing finally worked.Also none of them had enough clearance to use the stock dust seal lips. These little rubber rings that really seal out all the junk.I would recommend you order 3-4 of these bearings as its almost guaranteed that 2 are going to be unusable out of the box, and then just return them via amazon prime.
celso Suarez
Reviewed in the United States on August 26, 2015
Good. 100% be perfect thank you
Recommended Products