Your cart is empty.
Your cart is empty.DEI Aluminized Plug Wire Sheaths are constructed from high-temperature rated glass fiber material bonded to a heat reflective aluminized material. Plug Wire Sheaths are an inexpensive alternative for protecting specific areas on both ignition wire and boot locations from damaging heat generating sources.
Michael Dipasquale
Reviewed in the United States on November 22, 2023
Put these on your wire before you install the Wires on the motor. i needed needle nose pliers to pull the wire through.
Mongo Man
Reviewed in the United States on September 21, 2015
Just the thing to protect your expensive set of wires from a header. I used these in conjunction with a set of Kevlar 4" sleeves (which cover the boots).
Mike M
Reviewed in the United States on June 5, 2014
I was having a problem with my plug wire getting burned on my 5.3L silverado with pacesetter type long tubes. They are the old style with the number #5 tube kicked out for clearance. I was using normal braided covers for years until they got wet and burned through. I bought these and a set of JBA W08559 wires only to find out the plug ends on the wires are to wide to slip these over. I sliced two down the middle and wrapped the #5 wire then put the burn braided sleeve over those. Not a single issue since then.
Recommended Products
