Your cart is empty.
Your cart is empty. 1. One Touch Data Switching: This meter can display the measured AC voltage, current, accumulated time and frequency. The red and green LEDs help you to get the numbers easily. When the SAM CK key is pressed, the meter will change the display and the corresponding red LED will light up.
2. 1% Measurement Accuracy: This single phase energy meter is to use with excellent PC flame retardant material and accurate chip. The accuracy is 1% ± 2 digits, and the measurement speed is twice per second.
3. Simultaneous Display Of AC Voltage And Current: DIN rail AC voltage and current meters can display AC voltage and current simultaneously. For currents below 100A, simply pass the wire through the hole on the right side of the meter to obtain the AC current.
4. Data Storage And Zeroing: While the meter is displaying electrical energy, you press and hold the SAM CK key for 5 seconds and the meter will reset. The meter will automatically save the electric energy value and the accumulated time electric energy value when the power is disconnected, and the meter will continue to accumulate data when the measurement power is turned on again.
5. Wide Application: This AC power meter rail with built in transformer can meet the maximum load current of 100A. It can be used in schools, shopping malls, homes, industries, laboratories, etc.
Specification:
Item Type: Multifunction Detection Energy Meter
Model: SDM007
Material: PC
Measurement Accuracy:1%±2 Word
Display: AC voltage use 0.32 inches four red LED, AC current use 0.32 inches four green LED, working time and voltage frequency use 0.32 inches of five red LED
AC Voltage: AC80-300V
AC Current: AC0-100A
Electricity Power: 0.000-99999kwh
Power Frequency: 45-65HZ
Measurement Speed: 2 x/s
Pressing Method: DIN Rail Type
Working Temperature: -10-+60℃ 140℉
Working Humidity: 10-80% ( Without Condensation )
Working Air Pressure: 80-106kPa
Operating Instructions:
1.
