Your cart is empty.
Your cart is empty. Application:
Compatible with Ford F-150 Speedometer instrument display (2004-2008)
It doesn`t need to be soldered but just inserted in to its dedicated connector
Note: legs on LCD are very delicate and can be damaged easily
Screen Size: 60*32.5mm
Item Condition: New
Trappfarmer
Reviewed in the United States on July 7, 2024
Brighter than the original due to led lighting
Darryl Bryant
Reviewed in the United States on May 21, 2024
Fits my 2006 F150 XLT
Kevin B
Reviewed in the United States on November 22, 2024
Had to replace the display on my F-150 when it quit working. It was a pain to get to it but definitely worth the time and effort. It's been 3 years now and it has been working perfectly, no complaints.
Mike from WI
Reviewed in the United States on September 28, 2023
Defective. Didn't work. Reinstalled the OEM and was surprised it started working again. Traced root cause to bad solder joints on instrument cluster board. Resoldered bad joints then tried new one again and it still didn't work. Reinstalled OEM one and it's still working. Also noticed the diffuser on the back of this LCD would actually block out the backlighting which is unacceptable especially at night. Shop elsewhere for a replacement LCD (if needed) even if it costs more it's probably going to be worth it.
grant hurd
Reviewed in the United States on August 14, 2022
My Ford F-150 odometer& temperature display was dim a part of it didn't read at all. I purchased this part and replaced my display in about 30 minutes. perfect fit and easy fix $50 part and Ford would have replaced the whole instrument panel for $700--- $900
Technician
Reviewed in Canada on June 11, 2022
Perfect replacement for my 2005 f150 xlt.
Mr. Sunshine
Reviewed in the United States on December 5, 2022
It fixed the display on the F150, but a similar display for a raspberry pi would have cost 75% less..Update: installed in November, died the following April.
Michael H.
Reviewed in the United States on August 2, 2021
LCD is exact same size as per original, Its a little difficult to install with one person.Had my wife hold the overlay up and out of the way, while i put in the LCD.I used a small smear of die electric grease on the pins.Its only been one day but works perfect so far.I am in Florida so the heat killed the last LCD.Picture is of the new one installed.I would buy it again.
Dan Winfield
Reviewed in the United States on October 12, 2021
Packaging was very protective of this delicate item. The installation was a PIA. You have to take the entire cluster out of the dashboard, take the clear lens off the cluster and peel back the black gauge backing. I was told by an electronics technician that I should use dielectric grease on the prongs when installing the new gauge. The prongs are very delicate, you MUST pay very close attention to the prongs when reseating this gauge. If you have any questions please feel free to hit me up.
Recommended Products
$44.79
$ 23 .99 $23.99