Your cart is empty.
Your cart is empty. Descriptions:
Suitable for rc boat less than 30cm length
2 sets/lot Double Motors RC Boat Drive Set 130 Motor+Motor Seat+Copper Coupling+15CM Shaft+Propellers Kit for DIY Model Ship
130 Motor Specifications:
Size: 15.5*20.3mm
Height: 25mm
Output Shaft: 2.0mm
Output Shaft Length: 8mm
Rated Voltage: 3V(suggest use 3-6V voltage)
Voltage: 3V
Current: 80MA
Rotating Speed: about 10,000 turns
Voltage: 6V
Current: 150MA
Rotating Speed: about 20,000 turns
Weight: about 20g
Packing Includes:
2 x 130 motor
2 x motor seat
2 x copper connector
2 x 15cm length shaft
2 x propellers(1PC cw+1PC ccw propeller)
Customer
Reviewed in Canada on October 15, 2024
As advertised
Moto T
Reviewed in the United States on September 21, 2023
This was exactly the size propeller I needed for the small RC boat project I am working on with my grandson. Good price and fast delivery were a real plus.
G. Pierce
Reviewed in the United States on February 3, 2023
This item could be a four or five star.Four Star— Have the motors wired with polarity indicated for the counter rotating propellers included. These motors are small, the lugs are tiny, holes in the lugs are too small to pass wire through from a standard JST connector. Small size makes soldering difficult.Five Star—Fully wired, sold with a transmitter and 2 in 1 receiver/speed controller. Combo package could be under $75.00
MASTER MASTER LLC
Reviewed in the United States on September 10, 2022
thanks it arrived on time, but without assembly manual, I have to blindly asembleand, I have 4 shafts but I only used 4, what the other 2 to be used?Rgdstony
Guitarzan
Reviewed in the United States on November 8, 2022
I usually use a different prop set but this one came quicker. I’m very happy with this set. The solid brass couplings are high quality. The motor mounts hold well and have lots of mounting holes. It includes right hand and left hand props which press on. I normally use props that screw on but these seem to be solid. The outer tube is a good fit to the shafts. I like to mount them at about a 22 degree angle so the motor end of the tube is well above the water line. That way no water leaks into the bilge. I’ve used these same motors before with good results.
Recommended Products
