Shopping Cart

Your cart is empty.

Your cart is empty.

DNJ IMA1009 Intake Manifold Assembly for 2003-2005 Ford Mercury Explorer Mountaineer 4.6L V8 16V SOHC 281cid

4.3 (4) Write Review
Free shipping on orders over $29.99

$267.99

$ 99 .00 $99.00

In Stock
  • THIS IS BRAND NEW: DNJ® Intake Manifold
  • FITS: 03-05 Ford, Mercury / Explorer, Mountaineer 4.6L V8 SOHC Naturally Aspirated
  • FITMENT NOTES: Intake, For Engines w/ Heated PCV
  • DNJ Engine Components is a full line provider of Domestic & Japanese engine parts for cars and trucks.
  • We carefully selected DNJ Engine Components as the sole provider. DNJ has a 30+ year track record of quality, experience, and trust. It makes sense for us to carry a brand that would help us earn customer loyalty in the long run


Part #: IMA1009
Condition: New
Warranty Type: 1 year or 12,000-mile DNJ® limited warranty

This is a brand new DNJ® Intake Manifold fits: 03-05 Ford, Mercury / Explorer, Mountaineer 4.6L V8 SOHC Naturally Aspirated

Fitment Notes: Intake, For Engines w/ Heated PCV

Interchange Part #: 615-775

All DNJ® Parts carry a limited 12-month or 12,000-mile warranty whichever occurs first. This warranty is limited to the replacement of a defective product only.


K.S.
Reviewed in the United States on March 3, 2020
Very cheap product. Yes it works but I wouldn’t recommend and the rubber plug for the not used coolant port blows off after some time so that needs to be clamped better. Your better off spending the money on a dorman intake. Unless your not keeping the vehicle.
a. aldred
Reviewed in the United States on October 2, 2020
Good price fast delivery
COLORADO 25
Reviewed in the United States on December 1, 2019
I was going to rate this product a 1 star but everything about it worked just fine with one EXCEPTION. On the back right hand side of the intake manifold there is a rubber block off cap attached with a STUPID hose ring . The first road trip after the install everything went fine. No water leaks and excellent heater operation . So good to go , loaded up the rig and headed to a family gathering. When I merged on to a freeway I put the peddle down to come up to freeway speed and then it happened the STUPID hose ring let loose the rubber plug popped off and 3 gallons of antifreeze left the engine quite quickly. I was lucky however ,the rubber cap stayed on the back of the engine and I was close to a sprinkler supply shop where I found a gear type hose clamp and once installed plus 3 gallons of antifreeze ,we were back on the road. At first I was super mad at the supplier for selling a product is prone to failure and then I got even more upset with my self for not replacing the STUPID hose ring in the first place during the installation of the manifold . So there, It would be nice if the supplier reads this a makes the change before shipment . However If one buys this product be sure to replace the STUPID hose ring . Once that is done the intake manifold itself fits and works just fine and deserves a 5 stars
Juan
Reviewed in the United States on November 7, 2019
Needed a replacement intake for my Ford Explorer , the most important, when I buy replacement parts, is the how well it’s going to fit , will it go on without any problems, and it did , super satisfied with the part.