Your cart is empty.
Your cart is empty.This replacement accessory drive belt idler pulley has been engineered to match the function and performance of the original pulley on select vehicle years, makes and models, properly restoring critical vehicle operations. This part is compatible with the following vehicles. Before purchasing, enter your vehicle trim in the garage tool to confirm fitment. [Ford Explorer: 1996, 1997, 1998, 1999, 2000, 2001] - [Lexus GS300: 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005] - [Lexus GS400: 1998, 1999, 2000] - [Lexus GX470: 2003, 2004] - [Lexus GX470: 2007, 2008] - [Lexus IS300: 2001, 2002, 2003, 2004, 2005] - [Lexus LS400: 1990, 1991, 1992, 1993, 1994, 1995, 1996, 1997, 1998, 1999, 2000] - [Lexus LX470: 1999, 2000, 2001, 2002, 2003, 2004] - [Lexus LX470: 2007] - [Lexus SC300: 1992, 1993, 1994, 1995, 1996, 1997, 1998, 1999, 2000] - [Lexus SC400: 1992, 1993, 1994, 1995, 1996, 1997, 1998, 1999, 2000] - [Mercury Mountaineer: 1997, 1998, 1999, 2000, 2001] - [Toyota Sequoia: 2008, 2009] - [Toyota Tundra: 2007, 2008, 2009]
Orest
Reviewed in the United States on January 28, 2024
cheapest bearing possible, if it could called bearing at all. Be prepared to swap the bearing for your own cost
Marc
Reviewed in the United States on July 18, 2023
Bearing, pulley material, and overall construction is good - but the pulley itself isn't the right one for my car. 🤷♂️I was sent the wrong one.. first pic is the one sent to me, the second is the one on my vehicle. Needs a concave face, or it will cause severe interference and engine failure.
not4nuthin
Reviewed in the United States on April 19, 2023
Nice looking pully however, it does not fit a 1992 Lexus SC400. The bearing is too deep into the pully so no way to bolt it back to the engine.
dung q nguyen
Reviewed in the United States on January 29, 2022
Andrew
Reviewed in the United States on May 23, 2021
Incorrect for 1st gen LS400. Has the wrong profile on the mating surface for the washer.
Mstells
Reviewed in the United States on August 11, 2020
Bought for Lexus is300 which said it fit the car but when the bolt was tighten it would lock down the pulley so I just pressed the new bearing out and pressed it in my old pulley
STEVE S.
Reviewed in the United States on June 5, 2019
On my daughter's Lexus IS300, I had to substitute a smaller washer since the original would hit and lock the pulley. Other than that it seems fine.
Todd Sutton
Reviewed in the United States on February 5, 2019
This product was bought to fit a 2000 Toyota Tundra. It has the original motor. However, it did not fit/work on my vehicle. I had to order another one and it fit perfectly.
Recommended Products
