Shopping Cart

Your cart is empty.

Your cart is empty.

Dorman 630-110 Rear Passenger Side Drive Axle Shaft Compatible with Select Chevrolet / GMC Models

Free shipping on orders over $29.99

$122.07

$ 47 .99 $47.99

In Stock

About this item

  • Direct replacement - this axle shaft replaces the original equipment on specific vehicle years, makes and models
  • Complete kit - each shaft includes critical installation hardware and components needed for specific vehicle applications
  • Durable construction - designed to rigorous standards and tested to ensure performance
  • Trustworthy solution - backed by team of engineers and quality control specialists in the United States
  • Ensure fit - to make sure this part fits your exact vehicle, input your make, model and trim level into the garage tool


Axle shaft damaged or bearings worn out? This axle shaft directly replaces the original equipment on certain vehicles, complete with all necessary application-specific installation components. This part is compatible with the following vehicles. Before purchasing, enter your vehicle trim in the garage tool to confirm fitment. [Chevrolet Astro: 1990, 1991, 1992, 1993, 1994, 1995, 1996, 1997, 1998, 1999, 2000, 2001, 2002] - [GMC Safari: 1990, 1991, 1992, 1993, 1994, 1995, 1996, 1997, 1998, 1999, 2000, 2001, 2002]


JM-GM
Reviewed in the United States on June 1, 2021
This ships as a complete replacement including bearings, seals, studs, and axle nuts. The bearings are completely junk, use at your own risk. Bearing was marked "China" and a part number. Upon driving in with a bearing driver the first hit went fine and then it got exceptionally tight. I swung a few more hits and I knew from previous repairs I had done that it should be going in. Well, I swing really hard and the bearing then broke apart (still using the bearing driver). Said a few choice words and spent the next hour fishing the remains and broken race out of the axle tube. Upon removing the broken parts I found a very small circular sliver of axle tube (look closely in the picture of the broken bearing and it is on the left yellow sticky note). The replacement bearing in the Dorman kit was oversized by a few thousandths. I went to local parts store and got a good Made in the USA stamped "National 513023" bearing and a new Timken seal (wasn't going to use the China one). This bearing drove in nicely with only moderate swings on the bearing driver. I did use the axle studs that came with the kit as they pressed in nicely with no issues. There was a little water / rust damage on the axle itself but that was not Dorman's fault (Box was wet at some point and then sat). I did leave feedback to the seller (box was opened and re-taped closed prior to shipping) as it was third party and not Amazon. The axle cleaned up with Scotch brite pads and a flat file.
Kyle J Caldeira
Reviewed in the United States on March 15, 2019
Still in use today, installed it myself and it has been at least 2 or 3 years since then. Worth every penny.
Compucarracing
Reviewed in the United States on July 29, 2017
Worked Great, Great Deal!
inCS
Reviewed in the United States on February 18, 2015
Fit and worked well.
Recommended Products