Your cart is empty.
Your cart is empty.This replacement engine coolant thermostat housing is engineered to match the fit and durability of the stock thermostat housing on specified vehicles. It is designed to withstand extreme temperature changes to extend service life. This part is compatible with the following vehicles. Before purchasing, enter your vehicle trim in the garage tool to confirm fitment. [Jeep Wrangler: 2007, 2008, 2009, 2010, 2011]
Nicky
Reviewed in the United States on March 11, 2025
Works great in my 2010 Jeep Wrangler!
Karl H.
Reviewed in the United States on January 6, 2025
I ordered for my jeep mine was leaking not sure why it’s made of plastic as the hose flexes a lot. I’m hoping it will last.
Graham M.
Reviewed in Canada on September 6, 2024
Perfect replacement for Jeep Wrangler JK 2010.
Raymond M Suarez III
Reviewed in the United States on September 14, 2024
Fit perfectly fella high quality and been working well for over six months
screenames101
Reviewed in the United States on May 3, 2024
Fits my 2010 wrangler, name implies what it is. Quality is alright, 1 plastic like piece was inside thati trimmed out to prevent it from entering my cooling system.
Hope is lost
Reviewed in the United States on May 26, 2024
Fit perfectly. Would definitely recommend and would buy again.
Mojo Adventures
Reviewed in the United States on December 28, 2024
Fit is perfect on early model JK. No gasket needed as the thermostat O-ring seals the housing and you should replace thermostat also if you are doing the housing. Go easy on the mounting bolts (~10-12 ft lbs) for a proper seal. Everything working perfect so far. I will update this review if there are any issues with reliability.
Phil
Reviewed in the United States on November 17, 2024
Just buy this and a thermostat. I did not need the sea I bough as the thermo had a rubber seal on it.. working great. This was on my 2008 jeep jku 3.8
grant
Reviewed in Canada on October 24, 2024
A perfect fit for my 2008 Jeep JKU Rubicon with the 3.8L engine. Combined with Motorad 656-195 thermostat (Amazon $21), both these items solved my leaking thermostat housing. In my photos, the new combo is on the right. The last picture shows it wet underneath the thermostat housing but that is from the removal of the old one. Some may say to use a gasket but i didn't and it's not needed. Also remember to "burp" the coolant system ! i tried the funnel kit but it did not seal with it's rad cap, so i had to run the engine , with the rad cap off, for 15-20 minutes to get the air out (this is the messy way of doing it). Highly recommend.
Diego Casta Loza
Reviewed in Mexico on October 15, 2024
Muy buen plástico sigue al 100
timmy
Reviewed in the United States on January 14, 2024
I’m a certified mechanic and usually only purchase own products , one was on back order so i purchased This Dorman and it does not disappoint , feels like high quality and equivalent to the mopar , same engravings and super easy to install , would recommend and purchase again
Billy
Reviewed in Canada on November 29, 2023
No mess ,no fussSimple duplicate of the original
Recommended Products
