Your cart is empty.
Your cart is empty.Original equipment brake lines are highly rust prone. This Dorman OE FIX brake hydraulic line kit is made of upgraded stainless steel to resist corrosion. It's also pre-formed to fit specific vehicle applications for easier installation. This part is compatible with the following vehicles. Before purchasing, enter your vehicle trim in the garage tool to confirm fitment. [Chevrolet C1500: 1995, 1996, 1997, 1998] - [GMC C1500: 1995, 1996, 1997, 1998]
Franken Rods
Reviewed in the United States on April 24, 2024
Brake lines fit well. Install was fairly easy. Would buy again
Andy Bass
Reviewed in the United States on June 4, 2023
The longer ones are bent extra just to fit in the box and the one line going from the nest to the passenger frunt was about a 1'-1'6" short and had to use some make it do engineering to connect it all other lines you'll have to adjust to get it to fit.
Willie
Reviewed in the United States on May 11, 2021
It was incomplete as 1 of the lines that go under the cab wasn't there. My Chevy mechanic had to go out and find one. extra cost but now truck is doing well.
Jerry Newood
Reviewed in the United States on April 10, 2021
The brake line's fit perfectly, the only issue I had was that I need to buy two 1/4" unions for the.rear brake line, all the unions they sent 5/16", when two of them should be 1/4"
Albert
Reviewed in the United States on June 27, 2020
Wrong parts inside box that was labeled correctly. Ordered brake lines for a Chevy Pickup and received brake lines and instructions for a Ford F-150. Box appeared to have been reused.
Customer
Reviewed in Canada on December 7, 2019
Lines are good, and pretty accurate for routing. A few of the fittings with the kit were the wrong size, so I gave it 3 stars. Would have been 5 stars if all the parts were correct in the kit
Gerald
Reviewed in the United States on November 17, 2019
Fit was perfect.
Tanner
Reviewed in the United States on October 28, 2019
These lines were pretty nice overall. With the lines being pre-bent though, there were some issues trying to run the lines to the front 2 brakes. My biggest complaint is that they give you four of the 3/16 flared unions, when you need two of those unions to be 1/4. I would definitely by a bender as well to bend the lines straight from packaging and have the ability to adjust some of the bends for a better fit.
Dustin S
Reviewed in the United States on April 15, 2019
The line kit looked great when I first opened the box. I noticed then the instructions were listed for the wrong vehicle. The box was though labeled correctly and the lines matched up to the stock ones. 2 of the unions supplied were the wrong size and were too small. Lastly one when the line kit was totally installed I noticed the stainless line was cracked and leaking right where the bend was during shipping. Not a huge deal I just had to add a section. All in all the kit saved a lot of time and was worth the money. The downside was the things I listed above. I could have gotten a kit built on a Monday at closing time but beware not to be left stranded if you're installing this kit on a weekend or something.
Recommended Products
$147.28
$ 72 .99 $72.99
$65.00
$ 31 .99 $31.99
$60.25
$ 26 .99 $26.99