Shopping Cart

Your cart is empty.

Your cart is empty.

DPS6 Clutch Tool Double Dual Clutch Dry DPS6 Transmission Reinstall Reset Tool for Ford Volvo Focus Fiesta #307675

4.4 (1) Write Review
Free shipping on orders over $29.99

$85.99

$ 35 .99 $35.99

In Stock

About this item

  • 【Fit on】This DPS6 clutch tool is compatible with Ford Mondeo Mk IV 2007-2013, Galaxy 2006-2010, S-Max 2006-2013 plus Volvo S60 II, S80 II, XC60, XC70 II, V60, V70 III 2006-2013 Equivalent to OEM 205-1017.
  • 【Instruction】Install the special tool and compress the input shaft. Turn the threaded bar 20 turns after it makes contact with the input shaft.Spare Top Plate Part No 1681, Spare Force Screw Assembly Part No 1682. Adequate and appropriate lubricants to be used on threaded force screws and thrust bearing.
  • 【What you get】 Fixed plate x 1; ​Fixed remover x 3;Cound nut x 3; Dust cover x2; Input shaft x 2;Electromechanicalunit sleev x 1;Threaded rod x 1; Long bolt x 4; Short bolt x 2;Box x 1.
  • 【High Quality Material】The tool is constructed using durable materials to endure the forces associated with clutch removal and installation. It is crafted from high-strength steel.
  • 【Excellent Performance】The tool's design allows for precise alignment and engagement with the clutch components, ensuring proper installation and removal without causing damage to the clutch assembly or other transmission components. The 307675 DPS6 Clutch Tool simplifies the process and helps mechanics and technicians work efficiently and effectively on vehicles equipped with this particular clutch system.


Product Description

1

Removal

1

1. NOTE:Only tighten the bolt finger tight at this stage.

2

2. Using the special tools, turn the center bolt of the special tool with a maximum of 5 Nm (44 lb-in) of torque to push the clutch down to release the pressure from the hollow input shaft snap ring.

3

Use Special Service Tool: 307-675 Fixture, Clutch Remover/Installer.

Torque : 44 lb.in (5 Nm)

4

NOTICE: Make sure the lifting legs are installed on the clutch studs marked with the stamped manufacturing mark as

shown.

NOTICE: Installing the lifting legs on unmarked clutch studs will damage the pressure plate adjuster.

NOTICE: Make sure the lifting leg with the angle is in the location shown.

Use Special Service Tool: 307-675 Fixture, Clutch Remover/Installer.

5

Turn the center bolt with approximately 5 Nm (44 lb-in) of torque until the clutch is free of the input shaft.

Use Special Service Tool: 307-675 Fixture, Clutch Remover/Installer.

Torque : 44 lb.in (5 Nm)

6

Installer

1

Remove special tools.

Use Special Service Tool: 307-675 Fixture, Clutch Remover/Installer.

2

Use Special Service Tool: 307-675 Fixture, Clutch Remover/Installer.

3

NOTICE: Do not overtighten the special tool or damage can occur.

Use Special Service Tool: 307-675 Fixture, Clutch Remover/Installer.

Torque : 44 lb.in (5 Nm)

2

Yermin Gómez
Reviewed in the United States on April 13, 2025
Este kid es súper bueno para reparar el vehículo además muy económico súper recomendado