Your cart is empty.
Your cart is empty. Compatible with
band saw
10-325
Poly V Belt
Package includes:2 PCS
Chuck Shaw
Reviewed in the United States on September 17, 2024
It took less than a half hour to install and re-tension
Harold Hoops
Reviewed in the United States on November 13, 2024
These belts worked great on older model (green model 10-325) Rikon 14 inch bandsaw. It installed easily and has worked fine so far. I don't yet know how long it will last, but since there are two belts even if it lasts only a year I can switch it out and keep going. (The picture appears to show a fairly short belt, so I was a little nervous in ordering, but the picture might be a generic belt.)
Woodworker
Reviewed in the United States on October 27, 2024
No matter how many times I tried to get this belt in the right position on the pulleys it always tried to wander off track. It worked fine on the slow speed pulleys, but did not fit properly on the normal speed. I have since ordered the part directly from the manufacturer (Rikon), and it works perfectly. There's just something about the aftermarket brand that caused it not to track properly.
Ronald D. Eaton
Reviewed in the United States on April 29, 2024
Fit like a “Champ”
Mike Chibnik
Reviewed in the United States on April 25, 2024
The new belt was easy to install.
GoodWhiskey
Reviewed in the United States on September 7, 2023
Liked the quality of the belt and it was a snap to replace. recommend using brass brush on grooved wheel to remove any caked on wood that might have built up. Had not trouble putting belt on then ran the machine for 5 minutes before final tensioning. also recommend check tension after 10 hours of use. Good product and price point.
Richard
Reviewed in the United States on March 7, 2022
Fits perfectly on a 10-325 first gen bandsaw (with the green sheet metal). Just installed so I can’t comment on the durability. Will update if it proves to be an issue but 5 stars for now.
rx21825
Reviewed in the United States on November 30, 2022
This belt fit my 1st generation Rikon 10-325 bandsaw. This is the series painted green. The belt was shredded. The screw in the blade wheel was removed followed by the wheel. The shredded belt was removed. The tension controller was moved to the right. The belt was placed on the rear pulley on the wheel and placed back on the post. The belt was placed over the other pulley. (I was using the rear pulleys.) The wheel was secured with the allen screw and the tension controller was adjusted. I ran the saw and then readjusted to the recommended deflection. On this model and generation, the belt goes on the outside of the tension controller. There is a diagram on the machine.
Recommended Products
$35.92
$ 18 .99 $18.99