Your cart is empty.
Your cart is empty.Dual feed master cylinder with 2 bolt flange style mount. Use with Speedway brake pedal assemblies. This cylinder is similar to those used on mid-70'sCompatible with Fords (Compatible with Mustang, Fairlane/LTD, etc. with disc front/drum rear). Works well in disc/disc or disc/drum brake setups. Mounting Bolt Holes: 3/8" or 10mmÂ. 7 1/4" long without the pushrod, add 2" for the pushrod. 3" wide from the outside of the reservoir to the edge of the outlets. Mounting flange is 4" wide. Master cylinder is also 3-7/16" tall without a cap. Included push rod is threaded 3/8"-24 (fine thread) If you need a yoke for the pedal hook-up, use this Forged Steel Yoke. Pushrod boot included. Uses 3/8"-24 female inverted flare outlets. If plumbing with AN 3 lines, you will need two each of these AN to IFM Adapters. Learn more about selecting the proper master cylinder for your vehicle by reading our tech article. Brake System Selection.Â
David G
Reviewed in the United States on June 16, 2020
This is a universal master cylinder that does NOT mount up to universal brake boosters. Thank you for wasting my money.
Recommended Products
