Shopping Cart

Your cart is empty.

Your cart is empty.

Dynamite Nut Driver 5mm DYN2802 Hand Tools Misc

Free shipping on orders over $29.99

$6.99

$ 2 .99 $2.99

In Stock

About this item

  • Ergonomic rubber-coated handle
  • Hardened chrome vanadium shaft and socket
  • Precision 6-point socket
  • Long 75mm shaft
  • Storage Pouch


Key Features:Ergonomic rubber-coated handleHardened chrome vanadium shaft and socketPrecision 6-point socketLong 75mm shaftStorage PouchRotating end cap


Roger Swearingen
Reviewed in the United States on January 26, 2025
Still had to grind it down because the tool tip walls were too thick to fit on typical DB connectors, especially the male ones, the shield is too close to allow the tool to fit on the screw-net without needing a lot of pressure. Once it is ground down, it's great. Just wish the already did it, rather than me having to do it.
Serge Duch.
Reviewed in Canada on April 24, 2025
the head is thicker than needed. Will need to grind the head for better fit in stock ascent 18 wheel.
Matt B
Reviewed in the United States on April 25, 2019
I bought this to put back in my pit set to replace the one I'd borrowed out to use in computer repair-- it's the perfect size for motherboard standoffs and other bolts. Well, borrow, turned into permanent. so I had to get a single to put back into my set. Good tools!
JAMES R. MCCURDY
Reviewed in the United States on September 5, 2017
This is the perfect tool for removing the hex nut screws that anchor the D-Sub connector flanking the VGA input on opposing sides of he video card.
D. Davidson
Reviewed in the United States on July 3, 2017
Small but works great!
Customer
Reviewed in the United States on June 5, 2017
The nut driver was too short for me to get adequate leverage to fix the headlight in my 2010 VW Bug. I would look for one with a longer handle next time.Delivery was fine. I bought this because another person had commented that they used this same nut driver to fix their headlight on a VW bug.
Don
Reviewed in the United States on August 7, 2016
Use this tool to tune my Pedal Steel Guitar -- works great.
SandBag
Reviewed in the United States on April 15, 2016
I bought this to tighten the retaining nuts that are on the back of PC video card and VGA connections on Wall plates used in classrooms at my work. Easy to carry in a belt tool pouch. It's not as big and clumsy as some nut drivers making it easy to work in tight spots.
Kurt
Reviewed in the United States on May 16, 2014
Great little nut driver. Appears will last a long time . Will buy again if I lose it or need a different size ...