Your cart is empty.
Your cart is empty.Bradley W. Bleck
Reviewed in the United States on March 14, 2024
I was worried our kitchen cabinets would need some serious work, and money, but this stuff saved the day. It's easy to take off the old stuff (metal paint scraper) and easy to apply, just iron it on, trim, sand the edges, and stain. The repaired bits are all but indistinguishable from the original that didn't need repair. Biggest challenge, which wasn't that big, was matching the stain. I've been plugging away on replacing the bad bits but the cabinets look a whole lot better for this stuff.
john hartnett
Reviewed in the United States on December 22, 2023
worked like a charm
Mr low
Reviewed in the United States on February 12, 2022
Matches well with Columbia walnut ply. Adheres well and is not too thin. You can sand it gently with a palm sander and not worry about running out of veneer. I didn’t have too many splices in my roll but that’s always a gamble.
Somnos
Reviewed in the United States on November 10, 2021
I bought this for a project that required 47 feet of edge tape. With my overage on the cuts, I should have been left with at least 2 feet excess material. But I ran out before I could cover all of the edges that I needed to.Other than that, the quality seems pretty good and it was easy to work with. I use a block plane to trim the overlap.
Matt
Reviewed in the United States on December 13, 2018
Easy to use, high quality veneer. I’ve glued on veneer in the past but this stuff is far superior. I recommend using it with a small handheld iron to ensure it doesn’t overhear and lose its adherence.
kasako
Reviewed in the United States on August 20, 2017
The walnut edgebanding had very uniform grain all the way from the beginning to the end. Unlike one other brand that I have used before which was mostly sap, this was quarter sawn and looked really good when applied. The connecting seams were not noticeable, so the waste was minimum, since I did not have to discard any of the band. Overall, very satisfied with the product, will only buy this in the future for my edgebanding needs.
B&B
Reviewed in the United States on May 31, 2017
Looks great, well sanded, and easy application. It may shrink slightly when applying, or perhaps I was sliding it when ironing it on. Either way, I'd end up with a small gap from where I started, but easy to resolve by overhanging an inch at the starting point.
BW
Reviewed in the United States on December 16, 2016
This stuff was wonderful. I held in place with painters tape, set my iron on high and just moved slowly alone. Stuck first time. The width was perfect at 13/16 for 3/4" melamine. I used an edge triller then applied polyurethane to it. A+ recommended
Recommended Products
$15.99
$ 6 .99 $6.99