Your cart is empty.
Your cart is empty.
August-17, 2018, upgrade to version 2.0
2 Channel SPDT power relay interface module, high quality JS1-24V-F 10Amp relays.
Darlington transistor circuits drive relay coil, LED indicator for each relay channel.
High quality screw terminal block.
FR-4 fiber glass PCB, dual copper layers.
Taiwan DINKLE fireproof nylon material DIN rail mount carrier (not China low quality carrier), can support width 35mm / 32mm / 15mm rail, and the carrier can be taken apart for panel mount use.
Operating Voltage / Current (VCC): 18 to 36VDC / 60mA(at 24VDC).
Control signal voltage (IN-X):
0V - 0.5Vdc (low level), relay not action.
2.5V - 24Vdc (high level), relay action.
Output (relay switch) contact rating for each channel:
For AC, 125 / 250 VAC, 10Amp
For DC, 30 VDC, 5Amp
External dimensions: L49.5mm x W87mm x H43mm.
PCB dimensions: L47.35mm x W72mm x H15.5mm
Steven W. Snyder
Reviewed in the United States on March 28, 2021
The 2 reviews stating it did not work, did not understand how this relay works.In this 24VDC version, (I use it on a (26vdc circuit) connect minus 24vdc to the GND (either one or both, as I found they are connected internally). Connect the positive 24VDC to the VCC.To activate relay 1, connect a positive 24vc (from same source as I used for the VCC) to IN1 - then NO1 closes to C1.To activate relay 2, connect a positive 24vc (from same source as I used for the VCC) to IN2 - then NO2 closes to C2.The contacts are rated different for AC and DCFor AC, up to 250 VAC, 10AmpFor DC, up to 30 VDC, 5Amp
Matt in Raleigh
Reviewed in the United States on July 19, 2019
I used this set of relays to convert from a 24 volt DC output to dry contacts. My application only requires 24 Volts AC, so this product worked perfects. It mounts easily on a DIN rail. Kinda nice to have the indicator LEDs as well. I'd buy this again.
cory e.
Reviewed in the United States on June 3, 2019
i purchased the product but was not able to get it to work the way i had expected. There are not any directions that came with it. i reviewed the online info but still did not get the results i had assumed. according to the line diagram power should be passed through the relay but that is not the case. Also according to the line diagram a simple contact close from GND to IN-1 should close the relay but it does NOT
Laurie
Reviewed in the United States on October 10, 2019
It never worked and they wouldn’t replace it.
Recommended Products
$49.56
$ 25 .99 $25.99
$23.25
$ 10 .99 $10.99