Your cart is empty.
Your cart is empty.
Panel Mount Power Distribution Fuse Module Board.
Specification:
Work voltage: AC or DC 5~48V, total current rating 40Amp.
Dimensions: 150mm x 72.5mm x 29mm (W x L x H).
Input terminals: pitch - 7.62mm/0.3", current 30A for per position, wire size 26~10 AWG, stripping length 8mm, Metric M3 slotted screw.
P1 output terminals: pitch - 5.08mm/0.2", maximum current 10A for per position, wire size 26~12 AWG, stripping length 7mm, Metric M2.5 slotted screw.
P2-1 to P2-10 output terminals: pitch - 7.5mm/0.295", maximum current 6.3A for per position, wire size 26~12 AWG, stripping length 7mm, Metric M2.5 slotted screw.
Fuse holders for 5x20mm(DxL) tube fuse, factory-installed fuses T6.3Amp. with fuse fail indication function
FR-4 fiber glass PCB, dual copper layers.
Patrick R. Joy
Reviewed in the United States on January 20, 2022
CZH-Labs 12V Distribution board. Needed fuse protected DC protection. Works very well.
T. Strommen
Reviewed in the United States on March 5, 2020
Worked for a home security camera setup with several LED IR flood lights. Fuses of the glass type are good for higher than 32Volts DC, and to keep the amperage down went with a higher voltage power supply. With a bunch of 1/2 amp fuses and spares, the wires are well protected, and all of the service points are centralized in the equipment rack. Just what I needed!
Customer
Reviewed in the United States on December 27, 2019
Works as described comes with fuses
Cristina MV.
Reviewed in the United States on October 8, 2019
Fast delivery, product as described. Very happy with the purchase.
Customer
Reviewed in the United States on October 10, 2019
First quality electronic salon panel, easy to connect.
txSystem
Reviewed in the United States on September 30, 2017
Small, simple, instructions on board itself. Good value.
Paul S.
Reviewed in the United States on April 24, 2017
Shipping was Prime...avoiding the purposely induced waiting for non-Prime.Made up a CCTV power supply (from surplus parts!!) to get rid of all the "bricks".Am using this board to distribute 12vdc to CCTV cameras.The 1 picture with the LED lit.....that's what happens with a blown fuse. I pulled the fuse to simulate a blown fuse.Board is very well constructed....good solder, and found no excess flux - very clean and ready to go!!
DM
Reviewed in the United States on April 21, 2017
works great - built well - clean 10 x power distribution board - looks good and its inexpensive - replacing a DC power dist board that shorted burned up - hopefully being fused this one will not suffer the same fate - the red led-s light up when a port is active - would recommend.
Recommended Products
