Shopping Cart

Your cart is empty.

Your cart is empty.

ELING 110mm Car Marine Boat 120MPH Speedometer GPS Odometer with Tachometer 0-8000RPM with Red Backlight 12V 24V Waterproof

Free shipping on orders over $29.99

$77.99

$ 30 .99 $30.99

In Stock

1.:0-120km/h


2.Color:Black+black


About this item

  • Cut a 111 mm (4 3/8") diameter panel hole. You will need a minimum clearance of 55mm (2 3/16") behind the panel to fit the gauge. Put the gauge in the hole and screw down.
  • 9-32V Working Voltage, Red backlight available, Indication light: LEFT, HIGH BEAM, RIGHT
  • Securely fasten the GPS antenna, preferably outdoors (or inside front windscreen) so that it has a clear view of the sky to pick up satellite signal. Connect the antenna cable to socket in the back of the gauge. Do not cut cable.
  • OverSpeed Buzzer Alarm, Total Mileage Range: 0-999999miles
  • 100% Waterproof and anti-fogging protection



Product Description

CX-2C1R-120MBN-banner

Technical Data

- Tripmeter Range: 0-999.9 miles

- Odometer Range: 0-999999 miles

- OverSpeed Buzzer Alarm: Value Adjustable

- Indication light: LEFT, HIGH BEAM, RIGHT

- Working temperatures: - 40 to 85°C

- Operation mode: LCD display, stepper motor

CX-2C1R-120MBN-1

Easy to install.

- Cut an 111mm hole in the panel and allow a clearance of 55mm (2 3/16”) behind the panel to fit the gauge.

- Put the gauge in the hole and screw down.

- For the GPS antenna, you should securely fasten it in the flat position, black side upwards, preferably outside (or inside front windscreen)

so that it has a clear view of the sky to pick up satellite signal. Connect the antenna cable to socket in the back of the gauge. And do not cut cable.

CX-2C1R-120MBN-2
CX-2C1R-200KWS-3

How to be setting Tach RPM Ratio?

1. Turn on the power supply first.

2. Press and hold the mode button for 3 seconds to enter the setting speed ratio mode. then adjust speed ratio from 1.0-360 according to your request.

3. After setting, Data is automatically saved.

4. Please note: If your sensor is installed on the flying wheel panel, the RPM ratio is equal to the number of gears of the engine; If the speed signal takes from W-Terminal, the RPM ratio is equal to the half of the number of poles.

5. Normally, When the engine at idle state, tachometer shows 600-800rpm that means speed ratio is correct. If not, you can turn down or turn up speed ratio to check RPM difference.

Product Introduction

CX-2C1R-120MBN-4

Why does LCD show Err?

- Turn on supply power after installation.

- Then the meter starts to search for signal and LCD displays "COG".

- If there is still no GPS signal after 3 minutes. the LCD displays "Err".

CX-2C1R-120MBN-5

GPS Speedometer keeps counting?

- After installation in the first time, GPS speedometer needs to search for signal, that's the reason that LCD counts numbers all the time.

- After getting signal, LCD will come back to 0. It is normal.

CX-2C1R-120MBN-合集

Package Includes:

1x 2in1 multi-function gauge

1x GPS antenna

2x multi-plug socket

1x Installation Instruction


Recommended Products