Your cart is empty.
Your cart is empty.Installation Instructions : Do not stretch molding while installing. 1. Temperature of installation surface area and moldings must be at least 20°C (70°F).
2. Always cut moldings from the chrome side downward.
3. To cut, use anvil type shears (Ronan blade cutter is ideal).
4. Clean area thoroughly with a non-oily general purpose wax and grease remover – 3M general purpose cleaner followed by isopropyl alcohol is preferred.
5. Do not touch or contaminate adhesive once liner is removed.
6. Apply moldings on a flat surface only – not on a ridge.
Application: 1. Apply a masking tape guide line to the area molding will be applied. Do not apply masking to a freshly painted surface.
2. Clean area above masking tape guide using a general purpose cleaner followed by isopropyl alcohol. Use a clean lint free cloth.
3. Remove 8”-10” of adhesive protective liner at a time and apply molding using a rolling motion. Check molding clearance with all doors by opening each carefully. Once the molding is fixed to the car it should not be removed.
4. Using firm pressure (20-30lbs) rub molding in place with a molding roller (preferred) or a cloth to pressurize adhesive and ensure a maximum bond. Press hard with a blunt object on all ends to ensure permanent adhesion. Do not expose to heat above 93°C (200°F).
Chrome moldings feature a permanent, clear PVC top coating that protects the bright finish from weathering.
To ensure maximum molding life and to validate warranty, all cut ends must be sealed with a clear acrylic end sealer !
Cody Seiber
Reviewed in the United States on June 27, 2022
Good quality product, good 3M adhesion, easy install.
Kenneth Peckham
Reviewed in the United States on June 29, 2021
I did not receive the end caps as shown in the photo.
Kevin ramos
Reviewed in the United States on September 17, 2020
My roof rails were poping out all the time and honestly its a poor design from Ford however this Worked on my 2017 explorer. Looks great and had a great fit. Easy to install. If you're thinking the same make sure you have12 m6 1.0x12mm set screws with some type of caulk that will hold up agaisnt the weather. Took me about an hour.
JGratton
Reviewed in the United States on March 4, 2020
Great as advertised
C Wills
Reviewed in the United States on November 1, 2020
If you are purchasing for Ford Explorer Roof Rack delete ... I recommend the 1" wide NOT this 3/4" wide. The 1" will fill the gutter better and has slightly better adhesion but you would not know until you remove your roof rack. Make sure to order 1 foot more than you need for making clean and precise trims.
Recommended Products
