Your cart is empty.
Your cart is empty.Ball Joint Dust Boot, Hyper-Flex, Lower / Upper, Polyurethane, Black, Dodge / Ford / GM, Kit
Tony G Customer
Reviewed in the United States on May 24, 2024
quality product, great fit, easy installation only requires removal of tie rod as a unitdoes not require removal of the screwed end
Eddy
Reviewed in the United States on March 28, 2024
it fit on a 2014 nissan sentra , had some control arms installed in 2023 but had cheap ball joint rubber boots and they ripped open so i installed these and im hoping they last longer than a year
Kat H
Reviewed in the United States on February 23, 2024
I used these for the ball joints on a 2002 Honda civic and they worked perfectly. They seem well made and durable too. Time will tell but definitely worth the money to avoid a full ball joint replacement.
B.R
Reviewed in the United States on November 23, 2024
Disappointed wouldn't seal, kept popping off.tried it on several ball joints and tie rods didn't work on any of them
James D. Sherman
Reviewed in the United States on June 23, 2020
Item works as it should and is perfect to replace a torn boot. I was able to remove the boot on my tie rod end and replace it with this one. It fit well and seems that the material is better quality than the OEM boot. Time will tell if the boot will hold up.
Bman1386
Reviewed in the United States on January 10, 2020
The items were purchased because my ball joint boot was completely torn up .. sadly due to my install job when I slightly tore the boot I knew it was only a matter of time before this would come back to bite me .... These boots saved my day very thick and fit pretty close to perfect on my 2001 civic great item for the job needed
Sue
Reviewed in the United States on August 14, 2017
One size fits some. These sloppily fit on the tie-rod end ball joints I put them on. They work better than the factory boots that tore apart in a few hundred miles but leave much to be desired. The polyurethane material seems tough. I'm not satisfied nor dissatisfied as I could not find a properly sized replacement boot for my car anywhere. These will work, albeit, not as well as I had hoped for.
C. Snyder
Reviewed in the United States on July 19, 2010
These also fit my 1995 Ford Explorer upper ball joint boots. It appears to work well after 2 months replacing a torn boot and holding the grease in so I do not have to replace the upper control arm (when the left boot tore after only a year!). I just cut away the old boot, cleaned and regreased the joint and stuck this on it. The pressure of the assembly holds it in place. It does appears to move around and squeeze out some more grease as you drive, so recheck and wipe away excess grease after a few days. So far so good.
Recommended Products
![CTR CB0211L [OE Supplier] Front Left Lower Ball Joint Compatible with Hyundai, Kia Vehicles - Replaces 54500-F2000, 54500-F2AA0, 54500-F3000, 54530-F2000,](images/loading.gif)
$285.91
$ 99 .00 $99.00